hahaha i buy giant to flush the sytem but to cool it down im using spritzer

How about battery water for car? I've some battery waters from bhp and wonder what should I do with it.

i think it should be ok to flush the system,

Codomo so nice... But the price always more than ek

any casing suggestion with vertical mount psu?

This post has been edited by Dennos: Jan 29 2012, 07:32 PM

i have prob to make the loop neat
can anyone help me?
main prob - short of tube and rotary



owh how can i make the tube shiny again?


This post has been edited by irienaoki: Jan 29 2012, 07:40 PM

this is hopeless unless u are loaded with infinite numbers of rotary fitting.

paiseh
hahaha
thats all i have
nothing left
even inside my wallet

angpow from najib RM200?

err book's voucher?
became books ady

I think the first thing u need to do rotate 90degree of u CPU block

This post has been edited by pennykia: Jan 29 2012, 10:15 PM

if u use cylinder reservoir, it will look more neat, lolx

btw what the correct flow of the water ? from reservoir -> cpu block intake -> cpu block output -> raditor ( dun have outake intake rite ? just put any between 2 of the holes ? ) -> reservoir

just make sure the res must be located b4 the pump
the other are up to ur preferences (depend on ur casing,WBs and other)

anyway guys u can see in my previous post the tubes r cloudy
some are with pink cloud and some with yellowish 'finishing'
decide to clean it
"bathtub + scrub"



i scrub the inner tube using long screw driver wrapped with soft cloth
soaked it in detergent + tap water mixture for 5-10 minutes
then using the same screw i scrub it using car wax ..... hahaha
soak it inside the detergent mixture again and clean it with plain water
dried it under ceiling fan

and i save few hundred bucks
no need to buy new tube since the guys were out of tygon r3603 already




This post has been edited by irienaoki: Jan 30 2012, 03:07 AM

u use car wax to wax ur inner tube? this will reduce the friction so the water flow might be higher too. lol

seriously, car wax is some kind of solvent mixture that can remove dirt. i wonder wat will happen to ur acetal for long term.

---

Added on January 30, 2012, 6:53 ami notice ur tygon trademark is missing as well.

This post has been edited by Dennos: Jan 30 2012, 06:53 AM

since my proc didnt become 50 even touchered with prime .. guess my installation r correct 43 max i guess ..

---

Added on January 30, 2012, 9:28 amhe soak soak and keep soaking .. wax must flushed out b4 re-install ..
but better if lastly soak with distilled water .. just like lab's apparatus =O

This post has been edited by R3turn: Jan 30 2012, 09:28 AM

experimenting stage
we wait and see what ll be the result hahaha
if erode time to buy new stuff wakaka

can i know the medium range of price for loop to cpu & gpu for watercooling?

@babun_lapar - around RM1k++


anyway new experimento

soften and straighten the tube by dipping it in hot water



the good side r the tube became more soft and easy tho bend again and the tube oso in straight form

the bad side is by dipping it for a long time will make the tube look a bit cloudy ( translucent ).
few minutes (1 minutes perhaps) is more than enough to soften it

lol .. just now i potong my tube with still ekoolant water in it .. and split to my new mobo ..
was gonna cry o.o later on seem everything fine ..
gonna update my sig .. no more 125w phenom 965 BE
Im intel fan rite now ~