yah no problem .. .. just do it with patience.. spent few days loh ..

i did my cables sleeving first time with lots of care and patient .. and i love the results..

So far so good, only if possibly u could sleeve ur PSU for finishing looks ...

black would be great match with ur PSU color as well .. .

yah .. .nice, clean, neat and silent ...

hahaha ..what a nice combination of hardwares...

If that's the case then u have to get a third party cooler for replacement of stock cooler .. hahah

Anyway used to use 8800GTS and u could set the fan speed not to go up to maximun during gaming ...

It's not neccessary to have it spin to the max ....

hmm wait ar ... i already have the photo taken but still busy with the driver stuffs for this card ..

anyway there's not much of difference as compared to before ...

Then what sort of sound that u refers to ??

hmmm ??? Is there a thin layer of plastic cover on the cooler surface ??

I had it remove half way previously as the blower fan some how suck it in during running time... it makes noise as the fan blade hit the plastic layer....

@Xeda

Maybe u could shift the HDD one level up to the center and route the power and sata cables coming out beneath the HDD... that would reduces the visibility of the wires around the HDD cage...

If u can't get the PSU change u could give a try on sleeving and doing custom cables to extend the cable for gc and route it like what LittleLinnet suggested ...

keep up men .. it takes time and experience before getting to the best result intended...

What do u mean by worst ???

If the cables aren't long enough u could do extention ....

I have been doing for every case that used ,,, and it turns out good ..

Hmm the PSU u are using right now is the SS Strider ??

or a newly bought one ..

I thought the wires are long and able to play around with when comes to cable management ... . ... I almost gone for that PSU before ...

Anyway it would be good to be able to have the flexibility of extending the cables for better result...

Then extension is ur only solution here ...

For the sata cable u could only push it deep to the front of the HDD cage... nth more .....

as for the power cable u could only make a custom cable for both HDDs for a better look...

It wont coz the wrapping should be able to handle high temperature .. at least it doesn't melt during sleeving process.. so rest assured..

Anyway I noticed both case fans are intake .. what about exhaust .??

Doesn't the case need some ?

It should be enough as long as the density of the filter aren't too tight ..

Only intake required filter while exhaust doesn't ...

Good solution but why don't get a fan with lower RPM ... for better results...

You guys could get it from a shop in the corner nearby ATE.. it's located right after the store room of ATE...

there are various of Sata cables ... 90 degress, 10 or 15 cm ..etc

hahha ... the only way is practice, practice and again ... practice /

got photo to show how it looks like ???

What case is this bro ??? Kind tell much from the photo only..

anyway I think it's good enough already with so many HDDs inside ..

unless u have long SATA cables and opening behind the HDD cage,, u could route the sata cables to the end of the cage and come out beside the dual fans,,,