mod the sidepanel to have a window...then u can stare at ure cacing without having to open the panel!

jolipoli81 I also not so brave to sleeve those cable so i use zip tie to tie it all XD.

treason, after i mob i will cry for that XD. Now that casing ok already but now i get a case fand with controller, so have to challange again, else just leave it full speed.....2800++ rpm u know how noisy is there XD. ( Now i using heat sensor let it auto run the speed and feel better.)

Good solution but why don't get a fan with lower RPM ... for better results...

Em i feel quite hot airflow come out from side panel ( close to GC ).
And if afternoon hot, my room also quite hot. GC temp can go to 60ºC++. CPU is around 50ºC ++ if not wrong.

Now let the fan sensor and auto change fan speed is around 1400 rpm. Need to test afternoon how was it. If no choice then use back that fan's controler to control.

Now the problem is don't know where to put my fan sensor, now 1 hanging around GC's top, another 1 is hanging motherboard power cable ( 24pin ).

This post has been edited by vincent09: May 25 2007, 01:26 AM

Any idea would having L shaped sata cable be improving cable management?I am about to purchase a few of the Silverstone White Sata cable..

L shaped sata cable is it the the connector is L shape ? If is that i put that connector on my HDD the other 1 ( without L shape ) is connect to motherboard. Improving cable management? Maybe if you got more than 1 HDD and need to hide cable. For me i hide my SATA cable near the fan, so i need to avoid the cable attack by fan then use that L shape connector to make that cable not so close to fan.

I also did the same, which is facing the cables at the front fan side. However, i just wanted to replace those sata cables with those L shapes one and in the future, i am surely going to add more HDD capacity into my PC.Just wanted to buy them for future case now..lol..

If near the fan, for safety, i recomand u get some of it, But my L shape connector cable is come by motherboard. So is enought to use for me, now i'm using 2 SATA HDD and quite ok to manage the cable.

You guys could get it from a shop in the corner nearby ATE.. it's located right after the store room of ATE...

there are various of Sata cables ... 90 degress, 10 or 15 cm ..etc

Well, i am going to get the Silverstone one as it looks really nice. And hopefully when i receive it with all my upcoming hardwares, i will redo the cable management hoping i could do something better this time...

Upcoming Hardwares
Remember post a picture here akachester

This post has been edited by vincent09: May 27 2007, 01:45 PM

Lol..Not really anything special like most people upgrading here.

Just a new GC, the HR-05 SLI chipset cooler, some minor stuff and maybe a new CPU Cooler as well...

Anyway, i will surely post some pictures. I also wanted to learn how to become a better cable manager..LOL...

hahha ... the only way is practice, practice and again ... practice /

I've got a LL PC-7 too. And the cable seems to be hard for me to manage. The only possible way for me to manage nicely would be drilling holes to my case. But scared will ruin it

Guess, i am just contented with the PC-7 for now.Cable management seems to be easy with this casing.Try using the C5 and you will notice the difference..

got photo to show how it looks like ???

I feel my pc-60 more hard to manage because of the motherboard bottom there no hole to let all cable hide behind.

no more pics?

basically the first 5.25" is the suitable place to hide the cables..

u can install ur optical drive at the 2nd place or below it..

if u wanna drill the holes, better think twice and have a perfect plan so that the case wont be ruined..

If i put there then my 24pin mb power cable very hard to route to the mb section.