after upgrade to  2.3.4 DXKPB,now  i cant play Need For Speed (NFS) Shift, try uninstall and install it will be the same...is there got same problem with me?

any way for me to expand my cache size or how do i move it to sd??

i need yor help...after upgrade my phone cant receive or send mms...need some advice to enable it...
how can i upgrade my phone with official version from samsung kies after upgrade to 2.3.4 from your website?? do i need to downgrade to old version?

---

Added on September 19, 2011, 8:36 pm
where i can get this full-package froyo??
Samfirware only provide one-package froyo for this version..
I almost brick my SGA last night..
my SGA failed to boot up after reflash with this firmware..
it's took me almost 15 minute to bring my SGA back alive.. foohh.. 

my one no problem it can show the warranty (till Apr 2013). but dunno if the warranty is void because i upgrade GB manually    .

anyone can help?

if i'm using android 2.3.4 s5830DDKQ5 version, how can i use this ROM? do i have to flash with 2.3.4 KPB first?

not sure if cm7 for ace exists.. if so, can u give me a link? btw, for the question earlier, yes, u would need to flash in KPB first then flash in myth ROM

some more info:
actually, the dking has post how to format to ext4, but it is in vietnam language.

here is another option how to format ur sd to ext4 if ur already flash to Myth rom.  Another instruction (i think no need to use sd card reader,just copy and backup all entire data in sd in ur pc. After finish, just copy back the data to ur sd in phone)

how it will help

i am planning to flash FirstUA-ROM...anyone tried this rom before?

Hmm... will we ever get to use CM7 on SGA?

I tried Myth v1.2 in the morning, I got it done in an hour. I have been trying behradGH for the whole afternoon and yet still cannot get it done. What am I missing on the steps below?

- flash to stock GB 2.3.4 KPB rom
- go into recovery mode, install CWM 4.0.0.9
- wipe clean and reset to factory settings
- install bedhradGH from sd card

I don't see any error msg. It says Installation completed or something like that. Then I reboot. I can get until samsung logo and no further. waited very long but the status would not change. Battery very hot. When i flash back to stock rom, i see my battery half gone. Where is my mistake?

put it this way, in my personal experience, i find myself going to task manager more often to switch apps of, and clear things for more ram. With froyo, I dont use task manager so often. Because of my simple use, I am satisfied wtih froyo. It is, just an ACE not S2. So I dont do too much, expect too high.

Actually, I feel that titanium backup is not the best. It could be better, if the backup is like an image back up on desktop. Then when I roll back, it is complete. I don't have to press and confirm one by one. It is also good to hv this function, but there are times when you just want to restore everything while on the go. Anyone using any good backup apps?

OK, after putting back T.Backup apk back into the newly flashed rom, I install TB and then start restore. I chose batch restore, but after that, it starts asking "install" or "cancel" with each apk, one by one for all the apps that I have backup earlier.

Nandroid seems interesting. But "mybackup" is not... I do not recommend it.

CM7 RC1?

i want to asked abt a2sd, in the thread ( CM 7 2.3.7 Kang's build in XDA forumn) stated ext4 will be preinstall, but do i need to partition my sd card to ext4 first or not? kinda confuse here.....

---

Added on October 5, 2011, 11:00 ambtw i cannot use the #*272*imei# method after flashing to CM7 kang built....cannot connect to kies mehh...

actually what is ext4? i thought it was the partition format, which we can change using pc....so what actually ext4 preinstall means in this rom?

---

Added on October 5, 2011, 4:21 pmthis is for internal memory? what does it do actually?

hello...i just get my GA...my basedband version is s5830xxkph what its mean

just update by SGA... PDA:KC1 / PHONE:KC1 / CSC:KC1 (MM1).. this means? is it GB?