the picture i downloaded cannot see the brand of that bike.. but still nice.. haha...


Attached thumbnail(s)

I also don't know what bike... just look like FZ's brother... =.="

There's a Triumph in there.

I thought Triumph is an add-on sticker...

This post has been edited by Itsuki_Kun: Jul 25 2011, 12:59 AM

pocket very tebal lo.. that ducati..

btw..
want to ask u thianz and new guy
u all using hi-cam rite..

tepet got sound de rite?
tek tek tek tek.
mine 1 the sound very obvious when accelerate from low rpm
*ask aaron too .. he also test my bike liao XD

and morning found out my EO leak abit from the EO lubang..
cham..
try to tight it .. but very tight liao
what happen ar

err
using motul 3100 ....
can tahan how many KM or months(which comes first) ?

This post has been edited by Kaizzya: Jul 25 2011, 09:15 AM

thianz FZ cam

me high cam but x the super high cam (just found out CMS profile lebih kurang ride-it profile lebih kurang Yamaha S6 profile ) for LC cam

no prob here,
1) EO leak x enuf due to your leak (gas rosak/keras) or low will have sound...(check EO level, repair leak 1st)
2) pomen put the teppet gap too tight, mine set in 10, out 15 (if pomen x 1 set)
3) EO i still using 20w/50 so sure no sound (use this EO will reduce the sound)
4) the above kenot settle look for pomen will to do...

yamalube +/- 1200km not more than 1400km (feel your engine) this is almost what every say...
car mineral EO +/- 1600km not more than 2000km (feel your engine) this i tested d
semi between +/- 2500 (feel your engine) this refer other version guideline
fully between +/- 3500 (feel your engine) this refer other version guideline

This post has been edited by NewGUY: Jul 25 2011, 10:35 AM

err
now go check my EO lubang and see got leak ar not coz just now morning try to tighten the nut

too tight or too loose ?

tepet i noe have to look for pomen

should be no tek tek tek obvious sound la when accelerate from low rpm ..

editted:
no leak liao
maybe becoz just now morning i tighten the EO nut

This post has been edited by Kaizzya: Jul 25 2011, 10:18 AM

Found another way to make lc-es 5speed increase top speed , using 125ZR rear sport rim.Ori Enkei rim dam heavy.

errmm
125ZR de size rim behind is 2.50 ka?
and normally ori rim from manufacturer is quite heavy ..
good for stability

Oversea International Mat Rempit

oversea SBK Mat Rempit....

This one only call power, police also kenot do anything.....

This post has been edited by NewGUY: Jul 25 2011, 11:48 AM

edit:

ow this 1..
haha
crazy rider with crazy bike i must said ..


This post has been edited by Kaizzya: Jul 25 2011, 12:00 PM

ya, ori rim more stable but very heavy.

but ori rim got 2.5 size le =)
can put big tyre handsome2 XD

5speed lc enkei rim can fit in fz tire

that ghostrider is famous wan.. his bike very fast wan... police cannot chase eh... his bike no registration number... thats why he can do middle finger.. LOL..

tepet cannot too tight or too loose if possible set cun cun than will eliminate the tek tek tek sound but not all cam can set sui sui must leave some clearance. if not possible set cun cun better set it loose abit. too tight can kill the valves if worst piston and valves crash. than kaboom liao the engine and the block. better seek foreman opinion. because them who set ur engine. they know it better.

ok..
going back to tokico again XD

coz i want to track got piston ring de sound bor X_X
tepet sound too loud can't track
and the tepet tek tek tek sound only occur when low RPM

This post has been edited by Kaizzya: Jul 25 2011, 01:06 PM

wide rim and big tire is stable but you ll lose some top...

this some info i got

1.85 max recommended 100/80

2.15 recommended for 110/70

Stock LC ES 2011 is 2.5 use 100/70 (pomen say track tire size)

Since now got this size, then I ll try later bcos sure lighter than 100/80 and lower.....

jeli ow..
stock bike ady give so wide de rim ..

lc-es 5speed clutch very noisy , when shifting sound tok tok tok.