Outline ·
[ Standard ] ·
Linear+
<<XIII>>[ LYN Yamaha 135LC Club V13 ] <<XIII>>, We can stop anytime. But who wants to ?
|
SUSmelvinho
|
 Jul 23 2011, 08:00 PM
|
Getting Started
|
QUOTE(thianz @ Jul 22 2011, 09:39 PM) yes ... the 5 speed .... most teruk ... factory setting = 105-110km on meter ..... can go sampai 120 on meter .. sangat happy dah
Added on July 22, 2011, 9:40 pmapa 6th gear injextion ???/  5speed CDI cut 99=( CDI model (50c 145) cut til 6800RPM only Front sprocket 14(for pick up) if change to 15 should be ok..i just change my CDI to 1st gen CDI(127YS) just change my CDI and front sprocket to 15(SSS)-38(RKM), Pick up consider ok , top speed 143(GPS speed) 145(meter speed). |
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 08:24 PM
|
Getting Started
|
i went to 1shop near pj, he open my front cover and the cdi inside middle of 2side light., he plug in the stock cdi(tested 6800++) and he get the 1st gen cdi plug in (9k+)
after change the cdi , i test run with stock 14-38pickup very good but top speed =(
stock cdi with stock sprocket 14-38
1st gear : 0~15km/h
2nd gear: 20~40km/hr
3rd gear:40~60(if u hantam 99 can reach 70~80)
4th gear:60~85(if u hantam 99 can reach 100)
5th gear:80~106km/r
1st gen CDI with sprocket 14-38(good pickup but top speed sucks)
1st gear : 0~23km/h
2nd gear: 20~42km/hr
3rd gear:40~67km/hr
4th gear:70~86
5th gear:90~114
1st gen CDI with sprocket 15-38(pickup normal but top speed =) )
1st gear : 0~26km/h
2nd gear: 30~53km/hr
3rd gear:50~72(if u hantam 99 can reach 80)
4th gear:70~110(if u hantam 99 can reach 120)
5th gear:110~130km/hr(if u hantam 99 can go til 140+)
i test this using sprit highway so not long distance very hard to capture,i capture using another speedo that shop provide ask me test , each shifting will record automatic.
Added on July 23, 2011, 8:32 pmi found 1thing about new 5speed lc is the stock CDI, Sprocket and Chain all paria brand ,CDI black in colour with yamaha logo model 50c 145 , sprocket front 14TA(duno what brand), rear 38 RKM, and Chain also PARIA chain.
This post has been edited by melvinho: Jul 23 2011, 09:24 PM
|
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 08:53 PM
|
Getting Started
|
i went to 1shop near pj, he open my front cover and the cdi inside middle of 2side light., he plug in the stock cdi(tested 6800++) and he get the 1st gen cdi plug in (9k+)
after change the cdi , i test run with stock 14-38pickup very good but top speed =(
stock cdi with stock sprocket 14-38
1st gear : 0~15km/h
2nd gear: 20~40km/hr
3rd gear:40~60(if u hantam 99 can reach 70~80)
4th gear:60~85(if u hantam 99 can reach 100)
5th gear:80~106km/r
1st gen CDI with sprocket 14-38(good pickup but top speed sucks)
1st gear : 0~23km/h
2nd gear: 20~42km/hr
3rd gear:40~67km/hr
4th gear:70~86
5th gear:90~114
1st gen CDI with sprocket 15-38(pickup normal but top speed =) )
1st gear : 0~26km/h
2nd gear: 30~53km/hr
3rd gear:50~72(if u hantam 99 can reach 80)
4th gear:70~110(if u hantam 99 can reach 120)
5th gear:110~130km/hr(if u hantam 99 can go til 140+)
i test this using sprit highway so not long distance very hard to capture,i capture using another speedo that shop provide ask me test , each shifting will record automatic.
|
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 09:04 PM
|
Getting Started
|
QUOTE(thianz @ Jul 23 2011, 08:40 PM) » Click to show Spoiler - click again to hide... «
yamaha maresia memang kedekut ..... cooler tank pun kecil kecil ... CDI cut gila , carb lauya punya ... even belang carb also better than it .... use old LC mikuni 22 mm lagi sedap EO tht batang also sibeh pendek so ur bike now is kena force baru ada power lah ? but new carb fc save..last time my lc-ss normally 10km/day 90km/hr ron 97 can use only 5days. now my lc-es 5speed shell red colour(v-power) 10km/day 90km/hr can use for around 6~1week. |
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 09:25 PM
|
Getting Started
|
QUOTE(Kaizzya @ Jul 23 2011, 09:07 PM) RPM rev didn't go high mah  correct me if i'm wrong* haha. mayb the rpm low , fc save let me try with 1st gen cdi fc
Added on July 23, 2011, 9:28 pmQUOTE(0163119779 @ Jul 23 2011, 09:16 PM) Eh...kind tell u u change ur cdi also dunt always high rev...I suspect the spring of the new lc use palia 1..Better check it's using the old spring or palai spring...I means valve spring ...Check the valve too to confrom ...I think yamaha engineering set the limited in 6.8k frist is valve and valve spring can't tahan high rev...Block and piston rod and etc doesn't hv problem cause it was same with the pervious lc. Bearing and gear box is Fz150i 1...So limited urself though u change the cdi and etc/ i also got think about this , but i not dare to touch inside engine yet , still under warranty. This post has been edited by melvinho: Jul 23 2011, 09:28 PM |
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 09:44 PM
|
Getting Started
|
QUOTE(NewGUY @ Jul 23 2011, 09:37 PM) bro, calculate base on how much u can get per tank.... i used to get 200 km per tank, with 57mm block, stock CDI , 14/36 sprocket + 428 chain, stock carb, stock exhaust, rider 84kg and no air filter, tire front 80/90 and rear 90/80 
Added on July 23, 2011, 9:41 pmi tekan top often, never bother the average speed last time lc-ss if not mistaken can go til 180+ km per tank. all standard new lc-es 5speed havent calculate yet. |
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 10:45 PM
|
Getting Started
|
QUOTE(dragorc @ Jul 23 2011, 10:31 PM) do mean 1st gen cdi=first batch old lc punyer cdi? ya the 2007~2008 year lc cdi(original also got cut de not cut so much only), the shop say all cdi must got cut. |
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 10:50 PM
|
Getting Started
|
QUOTE(thianz @ Jul 23 2011, 10:48 PM) ya ... say no cut off itu bullshit ...... even u really found no cut off .... ur head part .. spring so lembut .. kenot tahan high rpm juga .... wait rosak 1st only change all, go back yamaha o0o them.this kind of quality and this kind of expensive price give this kind of high quality spare part. if no change cdi , suzuki shotgun 125 also can chase us.. |
|
|
|
|
|
SUSmelvinho
|
Jul 23 2011, 11:33 PM
|
Getting Started
|
lc-es 5speed engine tok tok tok tok , sienz geh
|
|
|
|
|
|
SUSmelvinho
|
Jul 24 2011, 01:28 AM
|
Getting Started
|
Just wonder which EO good for lc-es 5speed..
think next service wan go for penzoil. any idea?
|
|
|
|
|
|
SUSmelvinho
|
Jul 24 2011, 01:33 AM
|
Getting Started
|
QUOTE(thianz @ Jul 24 2011, 01:30 AM) shyan /@016 and i using ...... so far im using yamaha lube..quite ok..less noisy just abit heavy after 300km run. |
|
|
|
|
|
SUSmelvinho
|
Jul 25 2011, 11:37 AM
|
Getting Started
|
Found another way to make lc-es 5speed increase top speed , using 125ZR rear sport rim.Ori Enkei rim dam heavy.
|
|
|
|
|
|
SUSmelvinho
|
Jul 25 2011, 11:50 AM
|
Getting Started
|
QUOTE(Kaizzya @ Jul 25 2011, 11:41 AM) errmm 125ZR de size rim behind is 2.50 ka? and normally ori rim from manufacturer is quite heavy .. good for stability ya, ori rim more stable but very heavy. |
|
|
|
|
|
SUSmelvinho
|
Jul 25 2011, 12:10 PM
|
Getting Started
|
QUOTE(Kaizzya @ Jul 25 2011, 11:52 AM) but ori rim got 2.5 size le =) can put big tyre handsome2 XD 5speed lc enkei rim can fit in fz tire |
|
|
|
|
|
SUSmelvinho
|
Jul 25 2011, 03:28 PM
|
Getting Started
|
lc-es 5speed clutch very noisy , when shifting sound tok tok tok.
|
|
|
|
|
|
SUSmelvinho
|
Jul 26 2011, 10:58 AM
|
Getting Started
|
OMG , yesterday tapao by lc-ss 1st gen modded!!!!!
|
|
|
|
|
|
SUSmelvinho
|
Jul 26 2011, 04:50 PM
|
Getting Started
|
Anyone here Selling Small KOSO RPM METER?
|
|
|
|
|
|
SUSmelvinho
|
Jul 26 2011, 04:55 PM
|
Getting Started
|
QUOTE(NewGUY @ Jul 26 2011, 04:51 PM) go shop buy include install 100+... can intro which shop?KL or Selangor area  |
|
|
|
|
Quote
0.0506sec
0.75
7 queries
GZIP Disabled