1 bijik RM30-50, got 4 mounting. Workmanship shouldn't be expensive coz Wira mounting position is quite easy to take out. If you see your mounting rubber all cracked out or torn then you need to change it.

cute_boboi, Normally mechanic will ask to change the belt if it covered in oil. Not sure sikalan or not, but better change lar coz if the belt snap or come off from the cams your engine will suffer serious damage.

Thats just for few months..after done everything, u can drive more than 3-5 years..but if get new car, EVERY MONTH you need to pay that amount for 5/7/9 YEARS 

how can i check whether my wira windscreen in covered in my ins??

where to replace my windscreen in KL? cheap n good

sei pok kai~! just now went to midvalley, car park at B2, kena bang behind. Summore dont know who bang my car!! @$@#     

bro..he ask for the starter...not speaker.... 

eh Ron97 or 95?
if you rm10 go 40km, means rm50 go 200km... that's kinda bad lei
IIRC if i pump rm50 ron97 i get around 250km, if ron97 (rm50 also) i can hit 280km....again all 100% city driving lo.
will exhaust leak (small bocor) cause FC increase? or power loss? my low-end torque seems to be poorer than i remembered if i send to exhaust shop, i just afraid they simply say here n there need replace    thats why must ask u all for tips and advise first.

My wira manual 1.5 year 05 (just bought not long ago).

Is it the car seems correct when it is on 5th gear :

110km/h = RPM 3.5 
130km/h = RPM 4 

Sunny 130Y year 1995 RPM only at 2.8 when 110km/h
Honda City year 2010 RPM only at 2.5 when 110km/h

By the way, I spotted my wira speed reading is wrong (I compare to my GPS speed reading). So how do I fix it?

thanks bro will go back to check also and try ur way sad lah... now my car so smelly because the back seat there also water everywhere 

Thx for the speedometer reply  Just got quotation from Proton, RM 230 inclusive labor cost.
I think I need to fix the speedometer first, then only I see the correct KM/H match with what RPM.

How about aircond? (just added gas) Currently morning and night, the aircond is OKOK, the wind is cold, but not strong.

Afternoon, the car very hot, wind feel like blowing hot air instead of cold air and my car like sauna.

I figure out some of the possible issue that cause my car very hot :
1) Black color car with black color seat = absorb heat (cant fix)
2) No tinted currently - plan to tint it probably next month
3) For aircond part, refer below (havent do anything yet, due to no budget this month)

Showed to air cond mechanic: no problem at compressor, recommend to fix this issue once and for all by
a) The aircond pipe into the car doesn't cold at all. (I touch, and do compare to my nissan sunny 1995 130Y, my wira really feels like warm one)
b) Change condenser to bigger piece - RM 200-RM 300 depends quality
c) Need to release gas and test on compressor gao gao. But from outlook, seems like compressor still good
- RM 60 for gas refill
d) Change valve filter - RM 100+=

Anything else possible that make aircond dont blow cold wind during HOT afternoon day?
Coz, during morning & night, it is working fine with cold air blowing

there is light for that lamp but we cant see anything from that side..easy to say that lamp is ok but tiada pancaran cahaya .

my car can start, drive n no problem at all, when i on my car, wait the check engine light dim, then i juz start my car, later drive about 5-10 minites, the check engine light is on again~ = ="
if i off my engine n start the precedure again, no light, but after 5-10 minutes drive, it appeal again~ !@#$%^&*(
  wtf is going on?

hai all,

My temp meter shows one bar above the middle bar. It happened on daytime. On nighttime it shows exactly on the middle bar. Is it normal?

Or any problem with the radiator?

Hi! All Wira Owner here,

Need ask you all something. Yesterday my injection light suddenly appears in metre. Do you all know what happen? Really worry this problem.

won't it be dangerous if continue like that??
overheating can cause damages to the block, end up have to change the block..

Evo3 meter

Need to do wiring as I know. Around RM 300+ inclusive labour.

really.... cannot claim? demn... really bad luck..

Good to hear that it is plug and play. Been seeing some 1.5 Wira having rear disc brake... jealous them lor.. it look nicer with sport rims that got big lubang 
But upgrade brake also need JPJ approval ar? 

Guys, i owned a wira 1.5GLI auto, normal problem like all wira 1.5 auto, slow pickup . My friend owns a similar wira 1.5 but manual, and the pickup is very good, so i am considering to change my AT to MT, however i am noob in such things, and would like to ask the following question (please bear with me  ) :
1. Where can i find a mech to do all these stuff for me?
2. Whats the approximate price?
3. After some research on internet, i found some comment that it's better to change the engine as well, as some half cut shop provides engine with its manual gearbox as well, so i need comments (Frankly i prefer this option  so i would like to hear more on this)
4. JPJ issues, how do i notify them about the change?

Thanks

black smoke is probably caused by rich fuel mixture when engine too cold. I think your engine warm up too slow. If you have got your radiator overheating issue repair before then need to check if the radiator thermostat is installed or not. Sometimes incorrect sparkplugs also causing engine slower to warm up