MOS2 10W40 & Ceratec review:

Engine is really quiet and smooth now after running the car for about 100km since oil change. During idle with aircond off i can barely hear my engine running from inside the car. Good stuff i must say. Can feel a slight gain in pick up, but probably due to don't know what kinda oil was poured in before this by my cousin. hahaha. Good stuff Elton.

Just a note to potential customers who are doing oil change and adding ceratec. Be sure to tell your mechanic to not fill the new oil too close to the full mark as adding the ceratec increases the oil level quite a fair bit though i added less than 300ml. Forgot to tell my mech that and now my oil level is now above the maximum mark. Lesson learnt -.-

This post has been edited by nayte: Jun 30 2011, 01:06 PM

what should I use for e200k w210 year 2000?
needs 5L.

This post has been edited by 1337: Jul 7 2011, 11:12 AM

hi bro
im driving vios03
just need some review, there are diff between semi and fully
so which type u suggest to me?prefer semi synthetic or fully ,do pm me thanks

pm me also for persona..car just due for 1st service 1000km..prefer semi as i always change oil @ 5000km..

aku pakai semi pun, still service at 10k. xde issue pun

Get MOS2 leichtlauf 10W40 and Liqui Moly Ceratec from TS.
After Engine Oil Change about 100km, engine is quiet and smooth compare before oil change. Engine quiet until not realize engine is started.
Thumb up to TS bring good product to us !

i prefer to change at 5000km...any issue?

Just service my waja 4G18 and my friend's myvi with lambda primer and petrol!

LIQUID MOLY is hell better than E***S =D

there you go elton! free bump for ur poison yet awesome product! =D

jerry

better than Exxxx?
Have you tried it before?

I was thinking to tried Exxxx for the next change...

TQ.

any semi lub 5L packing ? how much ? pm me pls

yes bro. I tried E****. it don't feel the same with this oil.
=)

Hey bro, which grade of E**** and Liqui Moly you tried?

the almost same price? Molydedum??! lol

Hi,

Can pm me the total price for below item include deliver to N.sembilan.

MOS2 leichtlauf 10W40 (semi synthetic) 4L
Lambda Oil Primer
Lambda Tank Otto

Hi Elton,
this ceratec thing, can it work with other brand of engine oil or just with liqui moly?

for starters, the black engine oil was a bit of a surprise as im used to the normal yellow/golden ish oil colors. and the idea of putting something black into a just poured out used pitch black oil during the flush (with lambda primer too ) is kinda wierd lol

first impressions after im done servicing the car (for the sake of accuracy to people who care, i also had threebond done by elton, and lambda primer done prior to flush of old oil):

- car idle times are very quiet, vibration also greatly reduced.
- i can go into first gear at full stop, and the vibrations/jerking is very minimal (not to say completely gone, it will also be a lot more evident in the reverse gear), which is nothing i've experienced with previous regular mineral oil
- car temperature also rises a little slower than usual, radiator fan also didnt have to work its ass off unlike before, easily cooled down too if you're not reving the engine hard and driving for short distances

then later on at midnight about 4am, took the car for a full throttle ride:

- acceleration is greatly improved
- under 4-5k rpm engine still remains really quiet, the road noise/air con/wind leaking in noise is noisier than the engine lol
- very minimal improvement on max speed (topped around 165km/h downhill), however the time to get there was vastly improved

=edit=
oh ya forgot to mention:
driving a 11 year old proton iswara aeroback
and using mos2 10w40 semi syn

This post has been edited by Quazacolt: Aug 1 2011, 02:31 AM

hi bro cid, pm me for semi 10w-30. any chance cod near equine park?

PM me the best price for 10w40

bro..been looking for this product for ages. .pm me for 5L semi oil n oil additive..fast fast. .hv to service my car before Raya comes..

can ceratec be poured into diesel engine? (2007 Mazda Fighter)