ody enabled.. to be specific, after it posts, when it starts to load windows, it juz remain black..

BLCK Frequency = 101
Turbo Ratio = By All Cores(Can Adjust in OS)
Internal PLL Overvoltage = Enabled
Memory Frequency = 2133Mhz
EPU Power Saving Disabled

Load Line Calibration = Ultra High
VRM Frequency = Manual@350
VRM Spectrum = Disabled
Phase Control = Extreme
Duty COntrol = extreme
CPU Current Capability = 130%

CPU Voltage = 1.51
DRAM Voltage = 1.60
VCCSA Voltage = auto
VCCIO Voltage = auto
CPU PLL Voltage = 1.77
PCH Voltage = Auto
CPU Spread Spectrum = enabled

CPU C1E = Disabled
CPU C3 Report = Disabled
CPU C6 Report = Disabled

any idea why cant boot windows?

the ram default speed is 2133.. i upgraded the ram to ripjawsX 2133c9.. having limited spare time, so only short test.. what i hav tried so far is:

4.9ghz, able to boot in to windows, ran 10runs of linx
5.0ghz, 100 bclk@50x, able to boot to, ran 10 runs of linx
5.05ghz, 101@50x, vrm@500, llc@extreme, screen black after post..

100x50 and 100x51 both pass 10 run of linx.. bt when increase memory direct can't enter windows.. so I thk is bad memory oc.. thx.. will keep trying ltr

72c under load is definitely ok.. for the settings, its ok to leave on auto.. when its unstable then manually set

i dont think you need to re-apply.. its an one time job

if its of high quality ones i dun think u need..

i have encounter some that will dry after few years.. but those are stock tim provided by intel/amd..

its normal due to vdroop during stress test.. tats why we got LLC feature to compensate it

This post has been edited by jeff88rey: Jul 12 2012, 07:51 PM