Lowyat.Net Watercooling Club V2, Pictures of setups & screenies!
|
|
 Oct 20 2011, 11:10 AM
Return to original view | Post
#121
|
 
Senior Member
2,295 posts Joined: Jan 2005 From: Penang   
|
QUOTE(iaknesnah @ Oct 20 2011, 04:32 AM) mine is oc'ed to 4.2 also with ht off. and i also have 2 gtx480s in the same loop, maybe u need to service your loop. was it high like this when u 1st install? yeah, as suggested maybe can try clean up block. I get a 10c difference after cleaning junk inside my block.   my case is high temp on sandy bridge compare to 6 months ago after numerous time of changing wc component without cleaning the block. |
|
|
|
|
|
Oct 22 2011, 11:27 AM
Return to original view | Post
#122
|
|
Senior Member
2,295 posts Joined: Jan 2005 From: Penang
|
QUOTE(Norazam @ Oct 20 2011, 06:43 PM) 1 question, i got 2 reservoir, 1 the water is super clear, the second res is not so clear, why? try flush again on the not clear loop, maybe not as clean as the first one.already flush all the block and rad before installation... drain loop and fill loop 1 / 2 times will solve that. |
|
|
Oct 26 2011, 06:07 PM
Return to original view | Post
#123
|
|
Senior Member
2,295 posts Joined: Jan 2005 From: Penang
|
QUOTE(Norazam @ Oct 26 2011, 12:39 PM) unless the block manufacturer make just one wholw block for the board already covered everytyhing with 1 inlet and outlet I think they will comeout two seperate block for each pwm area. |
|
|
Nov 7 2011, 01:03 PM
Return to original view | Post
#124
|
|
Senior Member
2,295 posts Joined: Jan 2005 From: Penang
|
QUOTE(iaknesnah @ Nov 7 2011, 04:29 AM) not so hard laa.. 1st timer always will have blisters on fingers hahaahah QUOTE(monsh @ Nov 7 2011, 04:32 AM) yeap . blister . use rubber glove or rubber pad. quite effective. Even for old timer man . i stll got blister from the comp fitting |
|
Topic ClosedOptions
|
| Change to: |  0.0184sec
 0.35
 7 queries
 GZIP Disabled
Time is now: 27th November 2025 - 06:53 PM |
Quote