owhh..zippo got aledi...bought from ACE Hardwarwe yerterday some called gogo clean...dunno will work or not...

Try n c...hope you could clean it

i hope so....

Boleh laaa bang. Just soak it for awhile first to let it dissolve the grease and the slowly remove it lo. Kalo bole use cotton, preferably the one for facial

tisu cotton all i dun like to use since it tends to leave a piece of it on every pin....

// offtopic:

ei antonio... remember to take the pictures when you wash you Expect o... you know lor.. not every mainboard as lucky as yours that got chance to bath

should capture it down then share share

Evogenix

This post has been edited by Evogenix: Jan 11 2006, 06:14 PM

HAha...ye betol!
cara bersihkan grease from mobo and processor...

dun wan...i'll open up a class just for that particular reason....RM50 per cleaning lesson....hahahahaha

No thanks...so done the cleaning??when is the 2nd round?

not yet...still bz...

today got Drag Race at Nilai 3 summore..come lar join us...vrommm vroimmmm

Vrooom vrommm
Hey im waiting for your round 2

so antonio,

have u sent the mobo for RMA ?

anxious to know wether u have cleaned the grease or not..

hehehe....

GOOD LUCK BRO..

wondering how come antonio_zth always fried the mobo???
any technique archieve this?

not yet...stick using it ....can boot so no need clean lor...hehehhe....

the mobo problem was the bios at cold boot...boots fine with tccd....

hmmmm...let me guess:

-pushing the limit higher via raising vcore to max board can support and vdimm to ensure board are sucking a lot of juice.....

-bad luck....well not everybody is ong maaaaa....

-testing with no extra fans to create maximum temperature....

-sending feedbacks or my POV to DFI just so they can produced better boards in the future....

by the way tonight will be at Grand Modesto's taking pics....lets partyyy...ladies nite wooooooooooo

ic...

juz wanna knew what happen, afraid fried my mobo...
bcoz going pelt soon.

WC or XP-90C?

If you are going pelt, go WC. You won't really get much of an Air Cooled + Pelt setup.

juz get 1 to try 1st...
actually wanna buy those swiftech pelt...
anybody can help???
antonio_zth's is using air cooling only.

This post has been edited by Westley: Feb 3 2006, 01:39 PM

"ya...antonio_zth is on air only but his CPU temp is only 13c idle and 30c at load"

but you have to consider 1 thing...do you want to observe your cooling system 15-30min interval time everytime you fired up your pc.

the hot side of the peltier is around 68c at full load for 10 minutes of observation in my setup....

oic...

asked a friend help in getting me the swiftech peltier water cooling from U.S.
hope will get it soon.

erm..

i was thinking of pelting with Air Cool SLK900A

dunt get much results is it ?

i think its easier to carry around...

if water cool, i think a bit hard....