yea it's the same.. but for the older bioses they have 1.55 instead of the new 1.6

only the newer bios have version 1.6 memtest in there

anyone in for the DFI RDX200 CF-DR?

i'll be getting one to replace my ultra-D once it's available here.. and a DFI NF4 SLI-DR Expert as well..

at the moment a few things that people already know

6 layer PCB
4 dimms filled running @ 1T DDR400
4vdimm in small steps
15 levels of Drive strenght compared to 8 on the current nf4 (good for CPUs with cold bug)

lol bulk buy i saw a few people say will have it soon?

x800 i don't think so

i think 5900 only

lol i'll have to find a use for it..

if there is a bios that allows >3.2v like the one on the DFI NF3 250GB then you can..

and to be getting 3.3v you will need your 3.3v line to be around 3.4-3.5v

use a DMM to measure.. don't trust software readings

Changed the thermal paste on the chipset fan and have good airflow around your chipset area will do the job..

especially if you're using cards like 7800 or 6800 where the fets are @ the end of the card.. without airflow around that area it's going to be nasty

BH5 won't boot with CAS3

2.5 works fine

I wouldn't call those ES tbh.. afaik they don't sell their ES to general public..

i'm thinking yours have memory controller problem or it didn't meet the requirements for it to be a 3000+

try 510-1 for TCCD

704-2BTA works very well with my UTT and old school BH5

but of course there's no best bios for everyone.. only a best for u.. so u have to try them out

some say yellow works better some say orange.. u'll have to try them urself..

my yellow is better for BH5..

example is

orange = 250 3.3v .. error
yellow = 250 3.3v .. no problem

try this bootable disc

http://www.dfi-street.com/forum/showthread.php?t=22031

out of focus?

uhm.. install 3dmark again or update with the latest patch?