looking good .. u should cut the upper mesh at least and replace it with better 120mm fans .. and maybe some acrylic

i got no cutting tool
only got drill
BTW how's ur project??
cant wait to see the final result

u can use hand hacksaw

that steel a bit thick
if use hand hacksaw dunno how long it take
mayb my hand gonna ripped off 1st

This post has been edited by doob: Feb 15 2010, 01:37 PM

if cutting straight line, hacksaw is ok, but if curve abit hard for hacksaw

great. do u test the paint chipped off easily or not?

if use hacksaw how to start d 1st cutting??

already try
even d primer already hard to chipped off if using nail
use playar or other metal tool,then it will easy to peel

how come mine chip so easily zzzz.. any material with a good amount of force will chip it..

i already sand it with 200 grit sander lol.. .. u apply some clear coat??

wow 200??
i use 800 1000 n 1500 only
tat 2000 i wan use for lapping my proc
today i juz spray 1st layer only
mayb evening i spray another layer
i dun buy clear coat
is it important??
it use for wat??

its for making the paint resistant to scratches... clear coat is a clear transparent layer that u put on top of your paint ..

price?
same as normal spray??

i think if the purpose to make it a stealth look using a flat black paint don't need any clear coating unless you want make a piano finish at once.

i dun think can make that shiny
my house very windy
when spray got many small particle stick on it
FML

buy an air can compressor to blow out the small particles out of the case

no use anymore coz that small particles already dry-ed with the paint

where'd you get your paint from. a bit hard to find cheap paint nowadays. unless from those kedai runcit of hardware. haha.

yup
i buy from hardware
very cheap 1

drill 1 hole that can allow the blade of hacksaw to get through..then yeah u can start saw it

not sure if a drill can fit o.O.. most people use dremel first or a rotary tool to cut a small line for the hacksaw to go in..

new update for today

done spraying my side panel[actually the colour a bit not fully red but when snap pic it look fully red..ull know when u see it with bare eyes]



spraying the mesh front panel[DONE!]



so sad..that part actually no need to rivet yet n my riveter slide on it

but done spraying 1 more layer on it



put it back using glue



the hardest part of all

its nearly imposible to put the clip back without tearing the paint



start rivet-ing



my hand so gatal already to put it back

luckily got no defect on it



my room become like this

kena scold by my father 99