nice red HAF there...but if more red shots on that case,will be more like hell..more ganazzz

p/s : wow..clean room..

hehe sure can..but need to move abit the drill to get bigger hole rather than hacksaw i more prefer the choping saw..easier when cutting the curve area but take time to complete due to thin blade

@doob
nice..oredi applied with clear coat?

fuh.. very nice room there haha..

u got the clips back in so easily.. i had some bruises on my fingers and some deep cuts zzz working on those stuffs.. what do u use to pull it out?? flat head screwdriver??

run out of red spray
over use it on side panel

my place no got clear coat
hv to drive 40 minutes to get it
so sad

i got bed but i sleep on floor
already state there[the most difficult part]
hahaha
my nail feel like gonna peel off to put the clip back in
juz use my finger to take out n put it back
guna jari pon boley

This post has been edited by doob: Feb 16 2010, 04:47 PM

at my place, yes clear coat same price as normal color RM5 per can

if use metallic color, clear coat will bring out the shiny especially on flat surface

LOL, purposely mod your HAF for CNY?..

haha!.. good luck, following your thread

i use wanna make matte black
if put clear coat will make it shiny too??

thanks 4 d sapport
90% finised
juz a lil bit more work to finish my project

havent try it on matte color, i think it will give out shiny surface.

yep.. it wont be matte anymore..

nice job there.. keep it up bro!!

zzz i got girlish fingers, arms and wrist.. thats the weakest part of my body
ur paint was pretty much in tact too.. mine peeled quite a lot when sliding those thing back in

This post has been edited by reiben05: Feb 17 2010, 12:22 AM

like that matte gonna turn to metalic


go to gym bro make ur hand got otot2
that tear part is where i start the 1st clip
other part seem got no probs much

yeah im going to the gym alright.. biceps and forearms are quite strong for my size D: and i just started working heavy, before this was light2 ..

salute u on the paint.. mine was chipping all over when i drag/slide the clips in..

This post has been edited by reiben05: Feb 17 2010, 01:25 AM

mayb u can spray on it again
try to sand it kaw kaw 1st then spray

btw, it look like the HAF AMD dragon version, just without the AMD logo

i am dragon
i already finish my project
will upload final picture ASAP

Waiting for your dragon casing

i only do spray job
no cutting2
not very kewl

faster2..i want look u dragon pc!!!

sorry 4 d late update

here some pic 4 u all

Rivet-ing



close-up



99% finish



[my sis call this obor2 =.=]



Finish!!



Front view



Side view




done my simple project for this HAF932

Hope got ppl give me borrow cutting tool

wanna try cut2 this time