Wah, CNY fews day never see visit this page already many ppl asking questions. Ok i'll reply one by one below...
Added on February 17, 2010, 1:24 amQUOTE(gerogelow88 @ Feb 10 2010, 04:25 PM)
Hey bro,
The higher the uF the better it goes? will it melt the casing or not.. since is storing current?
Can it fix inside the car since the engine bay there is bloody hot =/...
The higher UF or not is done by increasing number of capacitors or capacitor types in parallel. Heat generated by capacitors is very low and will not increase over time to blow it off.
I have a customer that i customized a cigarette connector for him so that it can be put inside the car, but the performance should be decrease because the cable using on cigarette is thinner and high resistance.
Another way is to punch hole via your car firewall to your car, but this require longer power cable and would cost a little more. (You can place this order if you want, please PM me then).

Added on February 17, 2010, 1:26 amQUOTE(jovin @ Feb 11 2010, 01:13 PM)
eric, can this thing install in my ngv avanza ah?
yeah, car with NGV installed still using battery to operate, so VS is still applicable to your car.
Added on February 17, 2010, 1:29 amQUOTE(gregy @ Feb 11 2010, 05:56 PM)
IMO Eric already took great pains to insulate the box with foam insulation. If you want to improve it, maybe you can try to wrap the thing in exhaust tape or a reflective material like aluminum foil? Been thinking of doing that once I get the time

Alternatively if you want to drag the cables into the car you can, but you'd need very thick cables at least 2 or 4 AWG fully copper and shielded, and best to start from inside the VS itself. But if you look around, most VS are designed to be placed in the engine bay itself, like the famous Pivot, Guang Dao, Sun Auto etc.
Yeah, the insulator took me long time to cut and stick on, but that works well because after taking out from hot car and i peel off the insulator immediately and find those caps are still in cold temperature
This post has been edited by erictioh: Feb 17 2010, 01:29 AM