beside back exhaust fan also cant,totally no space.pic will explain it much clearly i guess




this is an old pic,the cable clips are edi removed so the space is there

This post has been edited by ZeneticX: May 13 2009, 11:57 PM

thats a good position
btw, where u got the diagram? lol

@ZeneticX
Bro, u can use cable tie to tighten the ccfl on the screw hole of the rear fan...

hmmm
suddenly gone to CCFL and cable managements in CM cases
can help with my HAF 932??



Attached thumbnail(s)

That's plenty of space in ur HAF932...Can put on bottom and left side (rear fan there)...

HAF just have too much space to put watever u want lor...even can put on the side panel also lar

you need a big mobo...ATX mobo...not mATX mobo

haha, last time said b4 la...
but Koki cant afford la
buy fans bankrap d

ya la
i planning to get 2 90CFM red LED fans to replace my side panel first
then hor i wanna ask also eh erm can the HSF of my gc mounted with a 80mm fan?

dn hav cable ties at the moment .i'll try mounting it beside the mobo 1st to see how it goes.if the light didnt spread well to light up the whole casing then i'll mount it back to the old position

bro..dont invest to much for fans...mobo is priority lor...get better mobo..then OC your proc kaw2...then go for cooling solution

aiyo mobo next time la
recommendation for cooling please?
i wanted good ventilation on my gc

Any msall enuff fan will do..Just as loong as you can screw into the heatsink.

hmmm...best cooling solution on non-OCed rig also no use lor...performance of the rig is more important lar

@koki,
wow your rig getting bater and bater oh~

how about trying out the vizo vga cooler?? i think it might be enough space .

if you want good ventilation for your GC..just put one fans la...that all..

@Koki,

You can use Vizo Propeller, which I am using in my rig 1 to cool down my passive GC heatsink (drop from 60C to 52C) :-



p/s the Propeller blue LED is quite bright too.

This post has been edited by WebWalker: May 14 2009, 10:00 AM

iinm, the heatsink is facing upwards, if put vizo propeller, the gc will block the airflow directly to the heatsink.

This post has been edited by Sib: May 14 2009, 10:01 AM

This is a image of a rifle bearing. You can go to this link to look at the explanation. It is near to the bottom of the page.

As you can see from this image, there is a oil reservoir(oil tank) at the back of the fan. So it is lock inside and cannot open it as it will render the oiling system spoil.

I think his heatsink can change upward or downward.

OR maybe just install fans on the heatsink will do the job ...