QUOTE(1212345656 @ Apr 22 2009, 09:59 AM)
So u mean i open SBSettings again and close all except wifi and brightness then wait it reboot, close again the phone den type in the apn settings??
here's a cool trick to make sure your iPhone doesnt latch onto EDGE or UTMS/HSDPA that incurs all those Telco data charges...
Irrespective of whether u wanna use bossprefs or SBprefs etc etc etc... try putting some garbage APN settings instead. Set it manually via the usual methods (settings -> general -> network .... u get the idea) .
And unless u have added nicely the carrier specific config plist files and the symlinks of the MCC/MNC, the iPhone will just use those garbage settings, and it will not be able to connect EDGE/UMTS/HSDPA.
There, problem solved !
BTW, this works not just for iPhones, but just about any handphone as well. If u dun want it to go on cellular data, just purposely mess up the APN settings and its all cool.
Added on April 23, 2009, 12:39 amQUOTE(davidgary73 @ Apr 21 2009, 11:22 PM)
Not sure if this helps. Try these settings:
Click Settings»General»Network»Cellular Data Network
APN: my3g
username: <blank>
password: <blank>
Check if your 3G is available after placing those settings.
also to add on, U-mobile doesnt have full 3G coverage nationwide. Their 3G coverage is somewhat limited to dense areas of Klang valley only. Outside of it, U-Mobile users are actually latched on Celcom network , and it is an industry known fact that Celcom does not open its UMTS (aka 3G) network to U-Mob users .. but they will "intra-roam" on the GSM frequencies instead.
Bottom line: its not the iPhone-3G's fault.
This post has been edited by mugenfoo: Apr 23 2009, 12:39 AM