Electrolux FL quite ok one.

Unless my TL not really ok.
Noisy for water pump & self weight for balancing when started wash, if unbalance would be stop and signal for adjusted balance then continue for input water.

TL carry too heavy load already still need it spin faster, i think the motor really over load can be spoil more faster than FL at all.

The worst case from the design on vertical tube motor work harder than horizontal FL drum from 30-50% water only.

If both washing same amount of cloths from TL used more water to wash top layer of cloths, unlike FL just used 40% water can be turning much easier.

But the overall can't compare from previous design via latest today design, so much improvement & more feature, even cold water these still can preform as well.

Even TL inverter model as well.

I believe the old design maybe can't easiy spoil or not durable at all.

In S'pore can be how much cheaper from $300 to 4k really bigger gap.

This post has been edited by kimsim: Dec 26 2014, 02:52 PM

why LG washer and no samsung?

samsung filter really more impressive at all.

Vios really empty like TL, if no budget then go with TL is not wrong

cause mine also from TL to FL today, after got FL you wont back to TL again.

Professor did you do the same step?

After washer and put into dryer before?

Just answer yes or no?

FL more durable than TL, if can't last then why most of dobi used FL, they should worried about service and cost issue right, but they never concern about that.

Just find out why.

Share my TL after washed and put inside dryer for dust collector is nothing wrong.

Are you all brands like Bosch or Electrolux and Miele won't be same issue?

Mold and smell even in the professional article writer they still prefer after wash and open the door for cycle in the natural air, even TL.

I hope I drive godcar, but these given me drove a BMW turbo.

Top load can save water?
Can see my photo before more or less cloths but the water level up to 70% of drum, not sure how many litre.

For example washing longer like FL but used less water & energy then which one you said so hai?

TL selling cheaper and less feature for who affordable user like entry level.

Used more water & also used much energy for rotation the motor too, why heavy load from the top & more water to carry that and still needed to turning = used more waste energy.

Like FL used less energy and less water able to do the job well, from you choosing and pay slightly higher then every months save more utilities fee for worth it.

If you stay in s'pore water selling higher than electricity than what you shall go with?

Definitely Front load lah, what else why waste so much water like TL as shown in the photo.

11kg TL before inlet water.


Also daily wash for 1 hour


Water level really up to 70% of overall drum.



Meant if you guys can go for green = save earth.

This post has been edited by kimsim: Dec 29 2014, 07:50 AM

If you can go for inverter model for longer run.

Bro where so simple to compare as wattage a just minor different.

Inverter motor more slient and quiet with realible too, even rubble motor to hold a motor also much durable with minor vibration when it is spinning.

Non inverter motor was AC motor more noisy and more vibration issue.

Since he has pay so much then why not get a better stuff for longer run.

If new tech really weak design so they won't continue to promote inverter again, they will hold back and sell for non inverter all the time.

Wanna improve should learn from household item.

Can explain what does the valve problem for?

But like my electrolux drain hose have to put certain height then the water won't going out.

Not sure is same issue?

Older design do not have built in pump that's why the hose as low, like newer come with pump have to put around 800mm from the floor area and come with U-bend case to hold the hose to becoms u shape then can be hold the water as well.

I knew my previous WM need the hose as Low as good.

Actually you saying is right lah, water valve to hold the water on & off.

This post has been edited by kimsim: Dec 30 2014, 12:12 PM

How old the machine now?

Make sure you know which one is the valve.

If your comforter too fat very difficult to slot in at all.

9kg no problem.

This post has been edited by kimsim: Dec 31 2014, 07:51 PM

Bedsheet if slim type then no problem lah.

King size also can

Simple below.


This post has been edited by kimsim: Dec 31 2014, 09:49 PM

TL?
Can try to screw to adjust height for front leg as balancing to control less vibration

This post has been edited by kimsim: Jan 1 2015, 12:03 PM