how to make the motherboard tray to open like this in the red circle ???
and tell me wat tool to use and anything that u use ok tq






i wan to upgrade my Casing to open like that PIC casing .....

This post has been edited by Pon&Zi: Jul 12 2008, 10:50 PM

I would use door "hook" / chinese called door butterfly to do it. but kinda heavy coz it's solid metal.

possible.. can get cheap one DIY or expensive one DIY, depends on your creativity.

what material do you want to use bro? Alu or Plexi ?

All you need is a drill,jigsaw,filing tools,most important is patience.

U can try hydraulic as well. buy those small 1.Not sure how it works.

where to buy the hydraulic thing and roughly about how much can get now ???

---

Added on July 13, 2008, 10:48 pmif i wanna use alu is it harder than plexi ??

wat the different between alu and plexi ?? which is better ??



This post has been edited by Pon&Zi: Jul 13 2008, 10:48 PM

rofl. what if you get sued by raidmax for copying their design? though it's a pretty low chance.

wah... bro plz la... dont report... i jz wan to mod the casing so the motherboard can go out the same way like the pic only because my Thermaltake Shark has a motherboard tray that go out at the other side

i am juz modding the same way..not to copy or steal any idea ??

1st-Alu is short a short form of alumunium.Plexy / Plexi / Perspex is a acrylic plastic like those car plate number.

2nd-To do a motherbord tray,you must know the thickness that you need to support all the riser (screws ),the motherboard,gpu ETC.

3rd-I think you can use acrylic as a start.Alumunium is damn expensive and kind of hard to get.Other than than,acrylic is easier to cut since its only a plastic material.

4th-Try to get all those materials you need 1st,then do a review on the net.You can ask anyone here to help you.

anyway.. again.. good luck to u and to me. wakakka.. gonna DIY my casing like that oso.

You also wanna make a motherboard tray bro??

I called door hinge.

What's that for? I mean what it got to do with the motherboard tray?

by the way bro... is it ok to do a motherboard tray with acrylic cause it sounds weird... because my thermaltake shark is not transparent at the side so can anyone help me

Yes,its not weird to make a motherboard tray with acrylic.Try to imagine a full transparent casing by sunbeam.The motherboard are made of acrylic.

For the side panel at the motherboard tray side,just leave it to non-windowed.

Just focus on the left side panel.

I think maybe alu is better cause can conduct heat some more and my casing is alu...

see this website my tray is remove without the back panel so now i wan it the out jz like that raidmax one

http://www.thermaltake.com/product/Chassis...k/va7000bwa.asp

i will show u the pic if anyone request

This post has been edited by Pon&Zi: Jul 14 2008, 12:22 AM

Using a alu is also not a bad idea.Well,its up to you to decide.I am just giving opinions.
Good luck to you bro.

ruimah kucing ko dah siap???

TQ for ur opinions i wan to ask have u make a motherboard tray before ???
Jz wan to ask only because u look so PRO

This post has been edited by Pon&Zi: Jul 14 2008, 08:46 AM

Haven't make a fully custom made.I only done a touch up to them.