guys, me just purchased a e7400 and noticed that the stock vcore is quite high; 1.30v. may i ask what is the stock vcore for this proc?
temp on idle is 45C even with BTVX. something is not right, its even higher than my previous Pentium D 930. pls advise. thx

bro i resolved the prob dy.
vcore went down to 1.18v after i restarted and enabled C1E in bios, together with speedstep kicks in (speedstep does not work before i enable C1E, which reads 1.30vcore and constant 10.5 multi).

333x10.5 prime 6 hours passed with stock vcore bro. good or bad?
tot of doing 400 fsb but couldnt get the right memory divider. well, this mobo doesnt hv much option on memory divider. i guess wat i paid was wat i get

i would personally opt for higher fsb if the mobo permits it.

cool bro. 3825mhz on stock vcore too?



This post has been edited by VT-Ten: Jul 14 2009, 03:07 PM

ur not having a bad AF casing with only 4C drop. i've seen some casings with 10C difference between open and closed casing

my pariah mobo cant allow me to do anything higher than 3.6ghz. stuck at 343x10.5

This post has been edited by VT-Ten: Oct 18 2009, 01:10 AM

cheapest 775 mobo from asus; p5kpl-am.
was pumping at 1.5vcore to do 400mhz with perf rams pinjam from fren.

heck, it cant even post at 400x6

running on 4:5
gee, thanks bro

i wish. there is no 1:1 option on this mobo (or was i too n00b afterall?)

yup, ram set to 667 and running on 343 FSB, the ram speed is already running at 428mhz.

thats the thing. borrowed a pair of perf rams, bump to 2.2vdimm and 1.5vcore, it still fails to post. even at 400x6 multi
voltage for MCH and everything else also been set to max.
therefore, i can only conclude that this mobo cant do 400 (at least for me)

nop, left the timings at auto

hi guys,
i got 3.6ghz on my e7400 @ 1.256v. prime stable for 4+ hours. tried to go further but it wont post




Attached thumbnail(s)

tried a few different setup, still failed. got frustrated and tried up all vcore, vmem, MCH, and VTT voltage to dangerous levesl, but still cant boot even at 400x6. i guess that's pretty much for my entry level board; p5kpl-am

i set it AUTO. the next increment is +50mv, which is higher than auto.
lucky for u, mine cant ler.

tried the max vcore avail in bios; +150mv
at 1.45 vcore still cant boot. time to change