yo guyz...do u use surfacer (mr surfacer) to check for any defect??mean after u mod,cut thisn that,doing seam removing,then use surfacer to check any defect,n if not satisfied,do some correction,n surface again,until satisfied?? or use the surfacer juz b4 painting,for the defects u all can correct it even without using surfacer.....juz asking coz don hav any talent in doing moding or cut this n that,usually after doin that i'll surface it to check for the defect,than repair it, surface again till i'm satisfied...somtime feel that it is not such an efficient way coz use lot of surfacer..huhu

by da way,donno whether this stuff has been discused b4... ,if yes sory for repeating it back....

This post has been edited by darth.lie: Jun 4 2008, 12:49 AM