Sep 18 2008, 12:20 PM
Newbie here. I have a question and I don't think I can go through all 30 pages looking for it so please excuse me.
My PG Strike is a little loose at the hip joint and will always bend backwards at the legs when I attach the striker pack. I heard from a friend that I could coat the leg joints with a few layers of liquid cement to tighten it a little. Any tips before I give it a try?
Thanks.
Added on September 18, 2008, 12:23 pm
QUOTE(naith @ Sep 17 2008, 09:36 PM)
When I draw panel lines on the model, the ink seems to bleed on to the model, resulting in it looking much thicker than I would prefer. When I try to use a cotton bud to clean it up, it kind of smudges all over the place. I saw in this image of someone doing panel lines
http://www.dalong.net/review/mg/mlp1/p/mlp1_mb1.jpg
Does anyone know what type of marker is being used? Right now I'm using the Gundam Marker (GM01) Or does anyone have another recommendation for doing panel lines?
What I do is use a cotton bud to absorb the excess ink and rub away the resulting smudges with an eraser or my thumb. Sounds a little crude (the thumb part) but that's what works for me.http://www.dalong.net/review/mg/mlp1/p/mlp1_mb1.jpg
Does anyone know what type of marker is being used? Right now I'm using the Gundam Marker (GM01) Or does anyone have another recommendation for doing panel lines?
This post has been edited by St0rmFury: Sep 18 2008, 12:26 PM
Quote
0.0393sec
0.13
7 queries
GZIP Disabled