Jul 20 2019, 11:01 PM
QUOTE(feekle @ Jul 26 2018, 08:40 AM)
basically 2 tier of PE, tier 1 (polygon stamp) cannot endorse design drawings, tier 2 (round stamp), PEPC can endorse design drawings etc. The assessment for this 2 tier is different as i was told.
Tier 1 (PE)
Under Section 7(1)(a), Registration of Engineers Act 1967 (Revised 2015), a registered Professional
Engineer is allowed to take up employment which requires him to carry out or perform professional
engineering services and use the stamp as approved by the Board of Engineers Malaysia
Tier 2 (PEPC)
Under Section 7(1A), Registration of Engineers Act 1967 (Revised 2015), a registered Professional
Engineer with Practising Certificate is allowed to practise, carry on business or take up employment
which requires him to carry out or perform professional engineering services for designated engineering
works subject to section 8 of the Act.
May I know the source of this info? I couldn't see this in BEM website. Thank you!Tier 1 (PE)
Under Section 7(1)(a), Registration of Engineers Act 1967 (Revised 2015), a registered Professional
Engineer is allowed to take up employment which requires him to carry out or perform professional
engineering services and use the stamp as approved by the Board of Engineers Malaysia
Tier 2 (PEPC)
Under Section 7(1A), Registration of Engineers Act 1967 (Revised 2015), a registered Professional
Engineer with Practising Certificate is allowed to practise, carry on business or take up employment
which requires him to carry out or perform professional engineering services for designated engineering
works subject to section 8 of the Act.
This post has been edited by Ic3dMil0: Jul 20 2019, 11:01 PM
Quote
0.0211sec
0.63
7 queries
GZIP Disabled