i'm using P5KR rite now.. haven't update my sig quite some time already.. well, my mobo just got back from rma.. LoL.. apparently the "press reset to reset bios" didn't work after countless times of resets...
the last time i did was bout 530 FSB using D9GKX rams on my e6300 rig..
as long as i could remember these were the settings used:

AI Overclocking: Manual
CPU ratio Control: Manual
FSB frequency: 530
PCI-E Frequency: 100
DRAM Frequency: 1060Mhz
DRAM Command Rate: 2T
DRAM Timing Control: Manual
CAS# Latency: 5
RAS# to CAS# Delay: 5
RAS# Precharge: 5
RAS# Activate to Precharge: 18
DRAM Static Read Control: Disabled

CPU Spread Spectrum: Disabled
PCI-E Spread Spectrum: Disabled

CPU Voltage: 1.4750v
CPU Voltage Reference: Auto
CPU Voltage Damper: Enabled
CPU PLL Voltage: 1.6
DRAM Voltage: 2.25v
NorthBridge Voltage: 1.55v

is there a difference overclocking the PCI-E frequency?

---

Added on May 24, 2008, 12:00 ambtw, i don't see modded bioses with the new mobos nowadays..
reminiscing my old nf7-s days~

This post has been edited by neurra: May 24 2008, 12:00 AM