gear changing quite smooth  .
bu the problem was even after the gear is already in position, the engine feels like still in free mode for a split seconds. quite noticeable. owh! my foot no longer on the clutch.
the engine has some free revs / slow revs problem too. perhaps, need some time to get familiar with the car.

problems prolly' caused by the heavily abused test car. the salesman promised me a test drive with another car soon.
btw, am not buying, my auntie is 
am holding on for the upgraded 2 doors neo. another proton in target. am not in audi league yet 

I found this   
Big clap for this designer http://forum.thesagaclub.com/viewtopic.php?f=9&t=34

It's for better pickup at low rpm. No need to rev hard to get the power. So low rev=fuel saving.
Bcoz the engine still new, u can see the figure is so so. Wait until  10000km and above.
Actually it's a good figure for a new engine.

Me just a new joiner to the BLMerz Club.

I booked the BLM on 31st Jan, so around 1 1/2 mth from now.
I have signed the agreement and paid the dp. I didn't get full loan tho 
Anyway, my black baby saga would probably reach in front of the gate next Wednesday 

Wait and see see!! 

i pump rm75(vpower) go for 385km and left one bar (1st time)..then shell hijau rm57 full tank n can go 203km and left another 4 bar.. but the 2nd time pump a bit 'lenjan' on karak highway...surprise a bit cause can go so many km before left 4 bar..

ching..i drive 50% federal road 50% highway..
torresism..can u pls calc for me

first time pump rm50=172km only...now i rev the car and speed up to 140km/h...i hate to c the check engine light show when i reach 90 or 100kmh..

lol never rev till da red line... max i rev till 5000rpm

RM60.....mline manual.....
RM0.1678/KM........hehe

Ofcourse you have to sign those documents, only bank will gonna approve your loan and let you loan a car right?

Just now at 7pm i go take my car ^^ so happy. No time to really test coz showroom very near my house and my dad wanted to test so let him drive instead the car smoke everyone at the traffic light =p
So far no defect detected and everything seems to be ok. Damn happy can't sleep want to drive the car 2moro.

Yeah, this is my latest FC report. Already drove nearly 1.5k KM still yet to go for 1st service, guess need to drive till nearly around 1.6-1.7k then only free to do service this sat.

Last time light blinking for quite some times already, still drive full car 5 person go supper, go home park the car, next day go to bank, stop, drive, another bank, stop, then only go pump petrol, so total drove more than 10km after light start blinking. So this time, I did the same thing, light blinking still drove for about the same mileage before I go pump petrol. Last time pumped RM50, and I get this figure before I pump petrol.



RM0.1380/KM   

new blm in action! wat a bad luck for the owner!

anyone noe how it happens? High speed accident o low speed accident? Do u guys tink saga is a safe car?

about the accident picture... how come the airbag doesn't trigger? from the looks of the damage, it has a good probability to trigger...

My fuel consumption is about RM0.15...

Can configure one meh? I only know how to silent lock la. As for auto lock it happens always once all the doors has been shut,wait 30sec and it will lock itself. Today went and pump petrol pay money came back the door was lock    luckly didt left the keys inside.

---

Added on March 24, 2008, 1:56 am

Not the door fault door is ok close nicely only the sensor not depress properly, too short i guess so i added padding and problem solve. 

---

Added on March 24, 2008, 2:01 am

Mayb you didt not properly break in the engine. I tried a proper way of breaking in the engine by once awhile reving it and now i get power from all ranges 1k - 6k rpm the car keep pulling when i 1st get the car same thing as you below 2k lacking in power after some happy reving for a few days the engine is more nippy.. Hmm dono is due to the voltage stabilizer or not because all this happens after i install VS as well.

Not rev it kau kau la, later will cause glazing and your piston rings will stop seating already. Its by mileage 1-200 km you keep it below 3k rpm and every 20km you rev it to 4.5k and sustain it for a short period if too long heat builds up you get glazing of the walls, then from 200-400km keep the rpm below 4k and once awhile or every 20km rev the engine to 5.5k and keep doing this by increasing the rev and limit of the rpm every 200km 5k limit,6.5k short burst and so on till u reach your 1000km of service. After the 1st service you will get a more nippy engine compare to those kiasi ppl who keep their engine below 3k rpm till the 1st service. Nway this is a risky method if you screw up and glaze your engine walls while performing engine break in thats it your performance and fc is not going be be at its full potential.
This is just my own opinion and based on many articles i read from the net, if you don't like it pls keep it to yourself and play safe this is just my method and im seeing results from the way my car is performing. 

This is my own opinion i will not be responsible for any future performance lost or high fc if you screw up

ok , 2molo i will booking new saga BLM , just pay RM 500 deposit first ,but need waiting around 2 to 3 month , and i wan to ask , if u buy new saga BLM , the saleman got free what item for u ? can let me know ? i will try to talk to saleman give me