Welcome Guest ( Log In | Register )

Bump Topic Add Reply RSS Feed

Outline · [ Standard ] · Linear+

Home Theatre Noobie in HT : Help for Basic HT System, Now With HT Brands and Pricing Too!!!!!

views
     
apisgogo
post May 12 2008, 10:55 AM

Audiofreakosauros 6.1
*****
Senior Member
925 posts

Joined: Nov 2006
From: Shah Alam
QUOTE(Moogle Stiltzkin @ May 12 2008, 10:22 AM)
Then what about sub woofer ?  hmm.gif
By the way did i tell you my av receiver was finally setup to my S750 creative gigaworks speakers and sub woofer in a 5.1 setup.

The audio performance has drastically increased !!! I am hoping to be impressed once i upgrade the speakers biggrin.gif
*
ha,

once u upgrade ur speakers, it will smoke ur creative speakers to downtown. after that u could throw it away smile.gif

hm i do recommend MS carnival 9 sub. u could get it around 1k-1.2k. quite impressive sub. can go as low as 24Hz. already makes my house shakes. smile.gif

This post has been edited by apisgogo: May 12 2008, 10:55 AM
apisgogo
post May 12 2008, 11:07 AM

Audiofreakosauros 6.1
*****
Senior Member
925 posts

Joined: Nov 2006
From: Shah Alam
QUOTE(megatron007 @ May 12 2008, 10:58 AM)
mean time... watch out ur AMP click ur speakers
btw.. YB APIS

good sub not suppose to "Shake" check ur setting n volume knob
*
i guess that subs/LFE (or speakers, settings, output sound) is personal preference lah smile.gif when there is a lot of LFE activity, i prefer deep bass. (this is what i meant for 'house shakes')

and 24Hz sub deliver that to me. of course if i have moolah, i'll definitely go for deeper LFE such as Velodyne DD-16/18



QUOTE(Moogle Stiltzkin @ May 12 2008, 11:00 AM)
Do you think if i get the following

RM3k only for 5 speakers - one pair BR2, one BRLCR and one pair BRFX.

Should i stick to the MA woofer, or get the carnival ?
Personally i like the sub woofer shake the entire house down, but the neighbours would get pissed. Is the sub woofer manageable by turning down bass ?  hmm.gif
Megatron - What you mean by AMP click ur speakers ??
I one time switched to a video source and the speakers were a bit loud, so it started squeling, until i turned them down to an acceptable volume. Is that what you mean't ?  hmm.gif
*
go audition yourself. easy smile.gif audio = personal. different ppl, different taste.

u need to get yourself to familiarize with setting-up your avr & speakers. the simplest way is to do YPAO calibration on your 663. plug in the supplied mic and ieneble the auto calib. then sit back.
apisgogo
post May 12 2008, 01:30 PM

Audiofreakosauros 6.1
*****
Senior Member
925 posts

Joined: Nov 2006
From: Shah Alam
QUOTE(Moogle Stiltzkin @ May 12 2008, 11:30 AM)
Hehe,
I tried using the YPAO mic auto setup but don't know how.

When i click test start and it count downs, i heard nothing and it doesn't seem to do anything. The control was set to AMP so not sure what i missed out biggrin.gif

Any ideas ?
*
really?

usually after enable the auto calibration, sounds (poping, pink noise) will come out from your speaker. read the manual lah smile.gif
apisgogo
post May 12 2008, 02:40 PM

Audiofreakosauros 6.1
*****
Senior Member
925 posts

Joined: Nov 2006
From: Shah Alam
hm...

try turn up the volume a bit?
apisgogo
post May 12 2008, 02:50 PM

Audiofreakosauros 6.1
*****
Senior Member
925 posts

Joined: Nov 2006
From: Shah Alam
QUOTE(Moogle Stiltzkin @ May 12 2008, 02:47 PM)
I think i did doh.gif  anyway i will try again when i get home.
*
aiya... i also dont know lah...

usually i plug in the mic, run the test... done!

hm, is there any error msg or what? try to enable the display on your 663.
« Next Oldest · Audiophiles · Next Newest »
 

Add ReplyOptions
 

Change to:
| Lo-Fi Version
 0.0196sec    0.58    6 queries    GZIP Disabled
Time is now: 13th December 2025 - 10:07 PM
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Removal Request
Powered by Invision Power Board © 2025  IPS, Inc.