Dec 9 2008, 09:21 PM
QUOTE(MyDevil @ Jan 22 2008, 09:48 PM)
ok. What I said earlier was the reverse 
On your Astro decoder, go to installation setup -> manual configuration -> modulation channel. Change to the lowest which is 21. This will change the RF output channel of the decoder. Then, you have to re-scan the channel on your TVs again to search for the right one. Good luck.
I tried this.... it worked..... but my eye strained after 5 minutes so I set it back to the original setting. On your Astro decoder, go to installation setup -> manual configuration -> modulation channel. Change to the lowest which is 21. This will change the RF output channel of the decoder. Then, you have to re-scan the channel on your TVs again to search for the right one. Good luck.
Better have bad view rather lose my eyesight
Quote
0.0166sec
0.52
7 queries
GZIP Disabled