i think i saw on XS forum where someone measured the thickness of AMD heatspreader, you might wanna look for that

normal ruler also can, as long as accurate

4400+ X2 Brisbane G2 - 3GHz @ default voltage ... huhuhu
and cheapo ProMOS KVR

Abit nF-m2 nView ... heheh.

not yet prime... wasting electric only

---

Added on January 9, 2008, 12:28 pmthat should be D9GMH.

D9 just means Micron DDR2 ... it doesn't indicate stepping/revision. not all D9 are as good as GCT/GMH/GKX

This post has been edited by soulfly: Jan 9 2008, 12:29 PM

that is because intel memory controller always have higher latency (loose timing)

I thought Windsors do not support half multis?

Windsor and Brisbane are different entities.

Or u mean Windsor have half multi since F3?

OK,my official entry with Pi32M



4400+ X2 Brisbane G2: 3003MHz
Abit NF-M2 nView
Kingston DDR2-800 (PC2-6400): DDR2-1001 5-5-5-18-24
Coolermaster Hyper TX

This post has been edited by soulfly: Jan 9 2008, 02:09 PM

I believe his is G1. The lowest speed for G2 is 4400+.

List of guarantee G2:
Athlon64 X2 5200+
Athlon X2 BE-2400
Sempron LE-1250

This post has been edited by soulfly: Jan 9 2008, 04:14 PM

i'm not too sure about that, but G2 is a refined silicon over G1

i currently have two sets of ram (2x1GB kingston and 2x512mb crucial) and both are value ram. different people may have different insight about overclocking.

to me, it's always about price per performance ratio. i can't afford expensive performance parts, that's why overclock comes into the picture. get the cheapest parts and overclock to match performance part rating.

but as usual, overclockable cheap stuffs are considered gems.

some other people just want to push stuffs to the limit, that's why they buy high performance stuffs.

I don't know but, I don't see the point of running high HTT because it doesn't increase performance.

instead of getting 5000+ BE, might as well get a 4400+ G2

people do video editing real time, not during sleeping

at lelong got... but a bit expensive at rm360

Dude, I think your voltage is too high. Mine did the same cpu/ram speed with default CPU voltage

damn... i should resist this temptation

speedfan is not compatible with your mobo

I have found something... thought of something actually.

Using built-in VGA seems to limit my memory overclocking. Before this, with 7300GT PCIe, my Crucial value can be overclocked up till 580mhz 5-5-5-2T with 2.3V. However now I'm using the built-in VGA, could hardly reach 555mhz with the same voltage and timing.