rubber bush, or silicone glue
How to make hole at back of casing smaller?, I have a problem.
|
|
 Mar 5 2024, 05:41 PM
Return to original view | Post
#1
|
 
Senior Member
2,236 posts Joined: Nov 2007 
|
|
Quote|
|
Mar 5 2024, 06:59 PM
Return to original view | Post
#2
|
|
Senior Member
2,236 posts Joined: Nov 2007
|
QUOTE(CommodoreAmiga @ Mar 5 2024, 05:53 PM) correct, but need to buy the right size (hole opening) good luck DIY |
|
|
Mar 7 2024, 01:50 PM
Return to original view | Post
#3
|
|
Senior Member
2,236 posts Joined: Nov 2007
|
QUOTE(CommodoreAmiga @ Mar 6 2024, 09:24 PM) My PCI x1 cable finally arrived. Damn...the thing just fit ngam ngam.... make sure it dont touch the casing ya, or you need to do something to insulate, else it might short circuit and burn. it's a double right angle Pcie x1 extension. Almost need to make another two holes. The edge of the adapter is touching the side of the case...And i don't need to do anything to the holes...because everything in there is cramp the card pushed slightly upward due to pressure from the Pcie x1 cables underneath it. For now, i just let it be. Hope it runs ok and no overheating. Thanks all!  |
| Change to: |  0.0148sec
 0.73
 6 queries
 GZIP Disabled
Time is now: 18th December 2025 - 07:43 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.