1-Put a layer of primer,then sand..the apply primer again..
2-apply the color you want (if possible,put 2 layer) to make it deep..
3- go for samurai brand (better go for compressor)

Try it,it wont make ur internal case scratch when u apply screws...

This post has been edited by ocz: Sep 10 2007, 07:03 PM

1- normally around rm 6-7
2- Its almost the same.
3- primer is like a undercoat..use whether grey of white (depends on what color u r gonna use)
4- glossy black is normal black (NOT matte and flat)..IF u paint it correctly and perfectly,i will give a mirror shine..can be found at hardware shop,motorcycle shop..price around rm 6-7

Hope that helps..

Bro,1 thing left,money..hahaha

Dude,do you have a drill...? you can drill the rivets and take off piece by piece..

---

Added on September 11, 2007, 11:51 pm

This post has been edited by ocz: Sep 11 2007, 11:51 PM

Here we go dude,take out all the rivets,take them into pieces,then you can separate your your mobo tray,hard disk and cd rom bay,top,bottom and rear plate..

Then,you can go on with sanding down the factory color..

Then you can go on to spray...

Try to look at this------> SPARYING TUTORIAL

This post has been edited by ocz: Sep 12 2007, 05:23 AM

HDD and DVD rom slot,you need to take it out by removing the rivets..

But the HDD and DVD cover,its screwless dude,just tear it off and it will not be virgin anymore..its to make sure your spray is level and smooth..

If you dont have drill,try to take it to any garage,ask them to take out those rivets,but need to pay a bit..

Dude,i think you need to invest a bit on tools such as grill..

Drill to take out the rivets,then you have to install back the rivets..you can find tools for riveting..

So dude,hows the spraying..? is it done yet..? did you did take all off the parts..?

Yup,pull it out,its useless..
or make a 120mm hole for better intake..

it depends on the front panel..

thats normal dude..if you want the spray to stay stick,use gun spray..

normally,normal spray will be tough if i sand it correctly,apply 2-3 layer of coating,primer..

lastly,try to apply clear coat..

There are many types of grit papers..

try 600, 800, 1000, 1200, 1500, 2000 ( use with sanding block)

then use old cloth to remove dust before painting..

yup,you can try it..or juz get 1200 and 1500..

do wet sanding as mentioned by omara