Outline ·
[ Standard ] ·
Linear+
Official TP-Link C1200 V1(EU) Firmware is out, Hidden WDS functionality works!, Page 29
|
X1X1
|
 Sep 23 2021, 06:43 PM
|
|
QUOTE(extercy @ Sep 1 2021, 03:01 PM) yea.. this is normal .. mine can suddenly not get connection until I do a power off, wait 5 seonds and on again. As I mentioned in my post above, the chip overheats and hangs .. sometimes until like 5-10 minutes later then it will reappear once the chip cools down enuff. At times, it just hangs permanently until a reboot. my getting weird, phone n laptop have 5g but pc don't have ......... 2.4g connections which is very very very slow (max 40 for 100m line). btw any good router recommend, good cheap n can setup mesh .... |
|
|
|
|
|
X1X1
|
Sep 24 2021, 12:04 AM
|
|
|
QUOTE(patricktoh @ Sep 23 2021, 08:28 PM) PC wifi card support 1. Dual band? 2. Support 5G channel 149 and above? Else change channel number between 36 to 48. it use to show ... but recently disappear and thinking of changing router as unifi TPlink performance is a little bit poor and minutes to restart. |
|
|
|
|
|
X1X1
|
Sep 24 2021, 10:30 PM
|
|
|
QUOTE(extercy @ Sep 24 2021, 07:46 PM) Unless you are near and in line of sight of the router, you will never get ok performance. Ok performance in the sense compared to wired LAN. This is the truth for a long time. The perception of WiFi being cheaper while in reality WiFi is very expensive compared to wired LAN for performance. before this i can reach 100++m for 100m lines, so not sure how fast should i get compare with cable. btw my question is abt missing 5g wifi, ok ?  This post has been edited by X1X1: Sep 24 2021, 10:34 PM |
|
|
|
|
Quote
0.0536sec
0.60
7 queries
GZIP Disabled