Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 Configuring modem/router as modem only, Configuring modem/router as modem only

views
     
safuan11
post May 5 2020, 08:53 PM

New Member
*
Junior Member
6 posts

Joined: Jan 2012
Hi @patricktoh and @Amimin,

I believe until 2020, Netis DL4480V has not stop giving headache to users haha. I face the same problem and now i want to configure it as modem only and want to cucuk a new router into it. I have been googling around on how to configure and i find that these steps are the most technical and reliable/ clear u can find. I just want to know, if i follow these steps, can i still use the hypptv/ unifitv?

QUOTE(patricktoh @ Dec 30 2017, 02:05 PM)
Found a simpler solution.

Make sure you backup current Netis settings before making any changes. So that you could go back to original condition if needed. Anyway do at your own risk. I hold no responsibility biggrin.gif

1. Go to Setup > PTM WAN

2. Disconnect VDSL_connection_1 then edit according to below settings (refer attached picture)
    - Channel mode: Bridged
    - Connection Type: INTERNET
    - Enable VLAN: ON
    - VLAN ID: 500
    - 802.1p_Mark: 0
    - Un-ticked all the Port mapping & VLAN tagging. Then "ticked" only LAN_1 in both

3. Save then reboot Netis

4. Login Netis to confirm the changes registered

4. Connect Netis LAN_1 to your router WAN port

You're ready to configure PPPoE and VLAN in own router. Most standard routers on the shelves come with Unifi profile so configuration is a breeze icon_rolleyes.gif

This settings confirmed by Amimin
*

 

Change to:
| Lo-Fi Version
0.0195sec    0.48    7 queries    GZIP Disabled
Time is now: 3rd December 2025 - 03:35 PM