May 1 2018, 10:16 AM
QUOTE(lamtwl @ Apr 7 2018, 01:11 PM)
Hi, I just apply for Unifi Lite 10Mbps (Subb) , it's use copper line, not fiber line, installer give me ZTE H267A Modem + Router as well. I wish to use my own Xiaomi Pro router and I had try both method provide above but seem like I fails to connect to internet using my own router. I am not sure the method above can work on Unifi Lite (Subb) or does it need special setting?? sorry for my poor english 
, hope can get help here, thanks!
You are lucky u get ZTE instead of Huawei, this is quite simple to do it, unbind vlan 500 from port 1 and tag PVID 500 at port 2 and connect your mi router to Port 2 , hope can get help here, thanks!What PVID do is actually watever local traffic going in to ZTE via Port 2, will be tag with 500, so your Mi router does not need to se any vlan. PVID (Port Vlan ID)
QUOTE(jas0nmack @ Apr 30 2018, 12:07 PM)
Hello all, Thank you for the great thread. I am trying to help my Malaysia office with their static IP and their upgrade to TM 100/50 Fiber. The technicians put in a new wireless router and I didn't know how the old one was configured so we're no longer getting a DHCP address of our public IP to our firewall. I have tried everything listed in this thread but I cannot get our Cisco ASA to connect via PPPoE. I tried to bridge the whole ZTE router as well as the instructions in here.
Hardware Topology:
Alcatel-Lucent I-240G-P ONT
ZTE ZXHN H267A
Cisco ASA 5505
Our previous TM device would give us our static public as a DHCP lease. Any suggestions would be welcomed. I assumed their wireless router did the PPPoE connection and then would hand it off on LAN-1. I also tried to bypass and go straight in the I-240G-P ONT and do the PPPoE in the ASA with VLAN 500 on the outside interface with no success.
*Edit*
Right now I am doing a static DHCP to the MAC of the Cisco ASA and doing a 1 to 1 NAT to accomplish what I need for right now (Site to Site IPSEC VPN) but i would really like to get any firewall out of the way between my firewall and the ISP.
can you share your "show run interface" so we may get an idea what have gone wrong,Hardware Topology:
Alcatel-Lucent I-240G-P ONT
ZTE ZXHN H267A
Cisco ASA 5505
Our previous TM device would give us our static public as a DHCP lease. Any suggestions would be welcomed. I assumed their wireless router did the PPPoE connection and then would hand it off on LAN-1. I also tried to bypass and go straight in the I-240G-P ONT and do the PPPoE in the ASA with VLAN 500 on the outside interface with no success.
*Edit*
Right now I am doing a static DHCP to the MAC of the Cisco ASA and doing a 1 to 1 NAT to accomplish what I need for right now (Site to Site IPSEC VPN) but i would really like to get any firewall out of the way between my firewall and the ISP.
another way to do it as bridging using PVID via zte h267a but it look weird that way lol
This post has been edited by amirsubhi: May 1 2018, 10:17 AM
Quote
0.0143sec
0.75
7 queries
GZIP Disabled