TP-LINK Malaysia Official Thread, Technical Enquiries and Support
|
|
 Dec 7 2017, 04:36 PM
Return to original view | Post
#1
|
 
Senior Member
639 posts Joined: Feb 2009  
|
QUOTE(arrsoo @ Dec 7 2017, 04:28 PM) notify me too bro if there is any good offer. BTW, do you know if OOKAS is selling the V1 or V2 for the c3150? V2. I bought from him during 11/11 sales   |
|
|
|
|
|
Dec 16 2017, 11:18 AM
Return to original view | Post
#2
|
|
Senior Member
639 posts Joined: Feb 2009
|
QUOTE(arrsoo @ Dec 16 2017, 09:54 AM) Is a v2 and that should be the latest firmware right? I did use analtser and acrylic that you recommended previously to set my c5 to optimum and i used back the same channel and settings on the c3150, it shows no overlapping but the wifi strength is somehow overall lower compared to c5. Have you selected IGMP Proxy V3 and leave link aggregation disabled? Didi you adjust any other settings of your router? Ipv6 is set to disable by default and i let it be. Qos is set to standard by default **P.S. just discovered that hypptv buffers when someone else is using wifi...hmmm...settings issue? |
|
|
Dec 17 2017, 11:41 AM
Return to original view | Post
#3
|
|
Senior Member
639 posts Joined: Feb 2009
|
QUOTE(arrsoo @ Dec 16 2017, 11:22 PM) thanks for the confirmation bro. I tried to reset the c3150 and re setup again and problem still the same. Switched back to my C5, all back to normal again, no buffering, full speed with 5G. Sighh....dunno whats wrong with the c3150 Bro, try to test around with wifi mode, channel and width. Try to avoid using auto channel and set channel width for 5G to 80mhz if you have not done so. I'm currently setting my wifi mode to n only for 2.4g and AC only to 5g. I can achieve at least 100Mbps for both wifi modes in speedtest. Also try to detach any external devices to the router first for testing purposes and narrow down the issue |
|
|
Dec 17 2017, 06:41 PM
Return to original view | Post
#4
|
|
Senior Member
639 posts Joined: Feb 2009
|
QUOTE(arrsoo @ Dec 17 2017, 04:20 PM) Wifi wise is ok, acceptable, in fact 2.4g gained more speed but problem lies with lan connection, all lan connection (hypptv and andriod box) suffer buffering, cannot even stream movie. Buffering will become worse when wifi is being used. Seriously unacceptable. Not sure if router defective or settings problem....headache! I have no issue with HyppTV though but I did encounter streaming issue (keep buffering) with my mibox via USB to LAN cable adapter. I'm now using wifi to stream and no more buffering issue, not sure whether my adapter issue or router Lan port does not work well with Lan connection via adapter |
|
|
Dec 18 2017, 11:04 AM
Return to original view | Post
#5
|
|
Senior Member
639 posts Joined: Feb 2009
|
QUOTE(arrsoo @ Dec 17 2017, 11:23 PM) Strange, by right lan connection is very straight forward right? not much to set with compared to wifi. Since all my lan connections has buffering problem, can i assume that my unit cud be defective? I m really at a lost on what to do now Ya it is strange that your Hypptv is also buffering because it is separated from Internet connection by its own. As what SilentVampire suggested, should try to contact your seller if still eligible for exchange since all possible causes we could think of have been tested out |
|
|
Dec 20 2017, 03:23 PM
Return to original view | Post
#6
|
|
Senior Member
639 posts Joined: Feb 2009
|
I have a question pertaining to C3150 v2 firmware. Is the router firmware same as the firmware being used by US set as based on its naming convention, they seem like the same ? I was comparing the latest firmware release between MY and US tp-link websites and noticed that the firmware build 170926 is not available in MY website (only build 170628 is the latest)
|
|
|
Dec 20 2017, 08:53 PM
Return to original view | Post
#7
|
|
Senior Member
639 posts Joined: Feb 2009
|
QUOTE(SilentVampire @ Dec 20 2017, 08:07 PM) Yes, they are the same. I have the router and they are exactly the same. So does this means I can update to the latest firmware from Tp-link US website? |
|
|
Dec 21 2017, 07:57 AM
Return to original view | IPv6 | Post
#8
|
|
Senior Member
639 posts Joined: Feb 2009
|
QUOTE(SilentVampire @ Dec 20 2017, 09:06 PM) You don’t need to bro. Just click update firmware on the router and it will update by itself, with the latest firmware. OK thanks bro |
| Change to: |  0.1063sec
 0.25
 7 queries
 GZIP Disabled
Time is now: 11th December 2025 - 06:42 PM |
Quote