hello.. im currently using nirox pump, mcr220 rad and aquaextreme cpu block setup.. and using 1/2 tubing.. i found that 1/2 tubing is so hard... i wan to use swiftech 655 pump but i comes with 1/2 tubing.. im thinking of changing to 3/8 tubing.. so it will be more soft and 'cute'..

the reason y i want to change to 3/8 tubing there`s a lot of accessories support until 3/8 tubing like thermaltake reservoir and flow meter and secondly 1/2 tubing is hard... infact many of bling2 for wc kit in malaysia support only 3/8 inch tube..

any suggestion? can i use 3/8 tubing at 655 pump?

or any suggestion which 1/2 tubing is a bit soft and gud?

This post has been edited by cookietiau: May 9 2007, 10:05 PM

huhu.. shawty.. what is ur opinion bout using 3/8 tube on swiftech 655 pump? i`ll use converter 1/2-to-3/8 inch.. it is possible?

do u hav it with u? can i buy? coz currently i`m using no brand tubing..

where can i get those tubing? clearflex ok aa?

or u hav better one..

does it fit with the 1/2 barb?

haha.. if like dat i would like to give a try laa... i want 2 meter of the tubing.. bro metalzone can u msg me the details?

update:

hahaa.. got my item olready.. i was sleeping n suddent when i woke up the item arrived already.. thanks to metalzone.

This post has been edited by cookietiau: May 18 2007, 11:02 PM

maybe u can go to air cond repair shop.. especially car air cond.. u can try ur luck at electronic repair shop...

but mebbe a bit pricey.. y dont u just use 120mm rad?