Oh yes i have the unifi olt technician manual someone else here found lying on the internet b4. Quite a few potential default passwords in the document

yes.... if you see my post.. i did unbox mine...  but mine is gen2+

I'm using Cloud Key Gen 2 from local reseller here (Subtel). They do carry them. 1k+ only.

Yes, 6GHz band is already allowed by MCMC.

My local Phone 15 Pro is able to connect to the 6GHz band of Archer BE800 from TP-Link.

Z Fold 3 6GHz band is disabled by Samsung Malaysia.

It's amazing, able to get around 1.6Gbps if within the same room as the AP.

However the range is bad, signal is pretty much gone after 2 walls.

Samsung claims to enable 6GHz on software update but not sure whether they did it at the end.

Guess I'm committed to the Unifi system even more now

Placed the pre order for Pro Max 24 PoE from my supplier for S$1190.

Hopefully it's reliable

3 more AP (1 U7 Pro, 2 TBD), one doorbell PoE, and the system is fully finished to my ideal plan. Maybe adding another NVR down the line to offload recording load off my CK

Honestly I thought the 2x2 is gonna be bad but currently it’s been great.

Not much devices with 4x4 and I don’t foresee any of my family members have devices that comes with 4x4 antennas on their phone, even my 15 Pro only has 2x2 6E

Speed wise quite comparable to my previous WiFi 6 EAP670, with less coverage I’d say unfortunately as some previous spots can get WiFi well enough but with U7 can’t but at least it’s more cohesive with my Unifi system. So I can add more down the line to improve coverage and it will work

But I will consider going higher if a U7E ever comes up but for now it’s good, tho I do hope they come out with an outdoor rated AP as I need one of that, currently my choice is only the U6 Mesh..

But a caveat, I’ve noticed currently weirdly with PPSK (VLAN segregation) some of my devices won’t get internet until I force them to reconnect and wait, and the AP will just fail to adopt if you got some rules and stuff and you have to hard reset multiple times for it to adopt. I think that issue partially has something to do with the 6GHz band causing issues with it just freaking out, hopefully there will be a better firmware that fixes these issues down the line

Done swapped to UDM SE, guess I'm committed now for better or for worst

Had a new UCG Ultra and trying to set it up (replacing an old USG3). It got stuck in the setup at the "Plug in the cable" stage where it's expecting to detect the WAN connection. Tried a few solutions found on google/reddit etc but none works (restarting the Telekom modem, restarting the UCG, etc).

Trying a long shot here to see if anyone has encountered similar issue and have found a fix. This "Plug in cable" issue seems to affect UDM devices too, and most of them pointed to faulty WAN port on the device.

TIA.

thinking to get the UXG-MAX but its not available in MY markets yet.. any other ways than driving into SG for it ?

Might be selling my UDM SE, if anyone is interested can PM

Gonna probably upgrade to UDM Pro Max for fun

2.8K but found a deal

Deals gone tho sadly, guess I’m keeping my UDM SE for now