Finally got C1D2. Any1 can advise how do u play wif the temp, watt, pre heat stuff?

So far i disabled the pre heat function.

Do u lower down the temp vs high watt? Or vice versa?

preheat is one of the beauty of the chip, normally i would go highest wattage and soft preheat to do the job. hard preheat seem too hard for me

only one selection, sweden post..

Sweden also cannot pakai, Mr. Johan


Attached thumbnail(s)

might be restricted again...haih..

need to check with FT ler like this..

Must be the new wave of Note 7 explo-fires... apparently a replacement unit caught fire on a plane in the US. So everyone's probably a tad twitchy when it comes to transporting Li-ion/Li-Po batts around in the air.

Which reminds me, I'm running SDI 25R AND 30Qs exclusively... and wondering if I should be worried... considering the initial explodolicious N7 batts were all SDI.

This post has been edited by Eiraku: Oct 7 2016, 02:32 PM

Aiyaaa tfv8 got two types / colors of o-rings ke Adui. Mine is orange.

Noob question, is Kanthal wire titanium or nickel or others? Trying to play wif my mod n set the default settings...

And the auto pre heat temp is set as what u defined? Like i set to 100c, it will always auto pre heat at 100c?

Was playing around wif my mod, the min pre heat is 100c?

kanthal is kanthal

I use F instead of C, 350-450F depend how the way you like it is quite generic for everyone. Mine setting might not be the liking for you. But treat is as a head start and move from there read more on the esribe forum you will be fine eventually.

The pre heat is an auto thing? N works on selected atomiser?

VT75 Nano is single 18650 right? Ok thanks. Will give it a looksie. Anyways, whats the best 26650 out there (available in Malaysia)? I used to have a MNKE 26650, but i sold it off. Thanks again.

Put it this way, preheat is work for your coil you have thicker coil u need better heating that you able to control the speed on the ramp up. Some people want Clapton to heat up real quick like kanthal some ppl like it slow the preheat is the role to allow you to do so. Not sure is automate but is basically adjustable. Play around with it you will find out more. But first go through the esribe tutorial and you will understand the function more. Don't skip the tutorial is useful.

Mana to get the tutorial?

just bought evic basic and serpent mini. also flavor dr brew rude beer. it is the flavor to cool ? my brain freeze to much after vape. how to reduce ? also recommend me setting coil kanthal wrap and power watt

also recommend me best local e juice creamy . setting for serpent mini too.

I don't use 26650 batts.

https://www.evolvapor.com/products/dna75

Scroll down to the Evolv Software section and click on EScribe Interactive Training Course.

Tks mate

aghh!

got raffle going on @ 11.50 usd per spot. winner gets to choose either;

rainbows end hexohm box mod + 120ml juice with mystery goodies
or
a custom marble resin dna200 mod with matching drip tip and rda

im damn tempted lol. should i try 1 or 2 spots?



30 spots. gaise gip me ur 2 lucky numbers pls

This post has been edited by duck v3: Oct 10 2016, 12:25 PM