Hi, I'm a new Unifi user and would like to replace the TRG212M(Old Router) modem given by Unifi. I bought TL-WR841NDv11(New Router) and flashed it to DDWRT.

I followed the guide below to retrieve my password
http://blog.amjed.me/recover-pppoe-password-trg212m-unifi/

Then proceeded to setup my new router by following the guide below
https://klseet.com/index.php/12-dd-wrt/dd-w...setup-for-unifi

These are my settings




I have an ethernet cable from Modem to the WAN port of the New Router.
Then another ethernet cable from LAN 1 of New Router to computer.

However even with this setup, I am not able to connect to the internet using the new router. It shows WAN IP: 0.0.0.0

Can any one point me to a useful guide or show me where is the problem at? I don't need HYPPTV.

Hi and thanks for your reply, there's no vlan option under the VLAN tagging section, what should I do next?

This post has been edited by henrytlh: Jun 27 2016, 01:21 AM

I'm already using eth 0.500 as shown in the first post. Will try your suggestion by deleting the eth0.600 later when I'm back home.

This post has been edited by henrytlh: Jun 27 2016, 08:29 PM

Sorry to break the news, it didn't work out. I reverted back to the stock firmware and use the "Unifi mode" instead

This post has been edited by henrytlh: Jul 9 2016, 01:30 AM

If you're still having the problem. Did you use the Malaysia firmware? it should write "Unifi PPPoE" if the firmware is correct