Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed
4 Pages < 1 2 3 4 >Bottom

Outline · [ Standard ] · Linear+

> [WTA] [HELP] Kancil 660 - Radio kereta masalah, kejap jadi kejap x

views
     
TSnaih
post Mar 1 2016, 06:49 PM

New Member
*
Newbie
3 posts

Joined: Apr 2012


QUOTE(lsm1991 @ Mar 1 2016, 06:36 PM)
Need to ask.... Im not clear bout ur issue ya haha, Speaker problem (head unit on, no sound keluar), head unit problem?(head unit keeps restarting) Or antenna problem ni?(audio keeps cutting off)

Edit:
I'm assuming hu problem, now ur wiring Ade 2 ends, while the one at ur head unit is OK, the other side or middle could be rosak... Check ends and cable dulu, now if confirm bukan this.... Then u check head unit.... U can hookup to another power point or (this is getting dangerous now, u might damage stuff if u don't know what it doing) test using some other means.... (Pandai pandailah replicate the power hookup... If external hookup pin kenot, hu problem lah tu, maybe connection dalam hu rosak
*
no, antenna is ori kancil radio..no sparepart for it then i bought new one

the new radio is ok for 2-3 days after installation..then starting to fail to boot after off engine..not everytime but 1/4 times was.. i must plug out then plug in back the connector to make it work again. all speaker and fucntion mostly functioning and never fail when it load..the only problem is after i turn off and on again ignition switch it fail to start .
EarendurFefalas
post Mar 1 2016, 06:49 PM

Getting Started
**
Junior Member
155 posts

Joined: Sep 2012


persoalannya ini cadangan?
csneo
post Mar 1 2016, 07:52 PM

Casual
***
Junior Member
398 posts

Joined: May 2005
QUOTE(naih @ Mar 1 2016, 05:24 PM)
ntfs, have effect?
*
For usb not detct, old system only detect fat32.

TSnaih
post Mar 1 2016, 08:15 PM

New Member
*
Newbie
3 posts

Joined: Apr 2012


QUOTE(ihavenoidea @ Mar 1 2016, 06:40 PM)
Hmm. I guess need to double check the wiring, electrical tape if x tarik ketat2 can loose easy.
Even twisted cable if vibrate can terlepas.

Also, check back the wire that you spliced. Those if x twist ketat2 and betul2 can cause fault.

Goodluck.
*
thnx bro, will keep that in mind

TSnaih
post Mar 1 2016, 08:19 PM

New Member
*
Newbie
3 posts

Joined: Apr 2012


QUOTE(csneo @ Mar 1 2016, 07:52 PM)
For usb not detct, old system only detect fat32.
*
thnx usb bro working now !!! thumbup.gif thumbup.gif
Attached Image

the only problem is it cannot start after long run engine and switch off engine. turn on engine again radio cannot start..nvm just be it shakehead.gif shakehead.gif
i will plug out and in the connector socket everytime radio die, NO PROBLEM
rudduan
post Mar 1 2016, 09:48 PM

New Member
*
Junior Member
37 posts

Joined: Nov 2010
Btw u koneksyun using provided socket or u cut wayar and solder them togeder??
sharpshooter85
post Mar 1 2016, 09:50 PM

Getting Started
**
Junior Member
128 posts

Joined: Sep 2011
From: Year 2070


Ada makhluk halus sembunyi dalam radio kau

Tu menurut pawang kampung aku la
TSnaih
post Mar 2 2016, 07:24 AM

New Member
*
Newbie
3 posts

Joined: Apr 2012


QUOTE(rudduan @ Mar 1 2016, 09:48 PM)
Btw u koneksyun using provided socket or u cut wayar and solder them togeder??
*
using provided socket by cut wayar and solder them togeder on old socket of the original radio..theres no way to install aftermarket rodio wihtoutkk cutting wayarre

Attached Image

as u can see the wire given plug is to plug in into radiooo asss..the wire mostly to connect to car (my car user 7 wire only, no power antenna etc)
rokiroad
post Mar 2 2016, 07:40 AM

Getting Started
**
Junior Member
108 posts

Joined: Mar 2009
From: hang suka arbok?
send back to lazada while you still have warranty.
then buy proper head unit. tongue.gif
TSnaih
post Mar 2 2016, 07:43 AM

New Member
*
Newbie
3 posts

Joined: Apr 2012


QUOTE(rokiroad @ Mar 2 2016, 07:40 AM)
send back to lazada while you still have warranty.
then buy proper head unit.  tongue.gif
*
probelem is when check back it is stated : NO WARRANTY

HAHAHAHAHA THE INNER MACHINATION OF MY MIND ARE AN ENIGMA
rokiroad
post Mar 2 2016, 07:47 AM

Getting Started
**
Junior Member
108 posts

Joined: Mar 2009
From: hang suka arbok?
QUOTE(naih @ Mar 2 2016, 07:43 AM)
probelem is when check back it is stated : NO WARRANTY

HAHAHAHAHA THE INNER MACHINATION OF MY MIND ARE AN ENIGMA
*
aduh. kalau camtu, pakai sampai rosak je la bro.
biasa la barang china memang gini. aku tau sebab aku pun suka beli.
sekarang aku faham. baik tak merasa dari merasa barang yang hanya berfungsi kadang2.
6216
post Mar 2 2016, 08:26 AM

Regular
******
Senior Member
1,003 posts

Joined: Mar 2014
Aku rasa ground tak betul. Aku punya pun kekadang cam tu. Finally when I got round to it, had to clean up the rust around the grounding. Baru ok.

NTFS tak boleh pakai kat situ. Format to FAT32.
ngeo88
post Mar 2 2016, 09:09 AM

New Member
*
Junior Member
48 posts

Joined: Nov 2009
look like you mess up the wiring to ignition and wiring to battery, there should be 3 power wire , one is to chassis should be connect permanent to car metal body to get negative (-); two Positive (+) 1. To ignition coil so when you turn key off radio is off. 2. To fuse, power direct from battery even your key pull out but your radio clock and memory still preserve because the power from this line are direct from battery.

user posted image

This post has been edited by ngeo88: Mar 2 2016, 09:12 AM
rudduan
post Mar 2 2016, 09:20 AM

New Member
*
Junior Member
37 posts

Joined: Nov 2010
QUOTE(naih @ Mar 2 2016, 07:24 AM)
using provided socket by cut wayar and solder them togeder on old socket of the original radio..theres no way to install aftermarket rodio wihtoutkk cutting wayarre

Attached Image

as u can see the wire given plug is to plug in into radiooo asss..the wire mostly to connect to car (my car user 7 wire only, no power antenna etc)
*
try ground the (-) wire dont solder to the faktori koneksyun...and do some grounding la ur car...old car is good good to do grounding...dont buy those cheap fake hks/pivot/greddy/apexi/r3/trd grounding cable...u can diy using better wire la...bestest using 100% pure copper zero oxide cable...but ini my pendapat la...lain orang lain opinion...
nasiputih
post Mar 2 2016, 09:26 AM

Getting Started
**
Junior Member
256 posts

Joined: May 2014

i am sorry, i cant help chu.
but, mybe check if got nasik kukus stuck in radio?
lsm1991
post Mar 2 2016, 09:27 AM

Casual
***
Junior Member
309 posts

Joined: Feb 2012
QUOTE(nasiputih @ Mar 2 2016, 09:26 AM)
i am sorry, i cant help chu.
but, mybe check if got nasik kukus stuck in radio?
*
seems legit, username checks out! rclxms.gif
kurangak
post Mar 2 2016, 09:30 AM

certified /k addict
******
Senior Member
1,170 posts

Joined: Apr 2011
From: Deus Vult



wiring ko ada problem
TSnaih
post Mar 2 2016, 10:36 AM

New Member
*
Newbie
3 posts

Joined: Apr 2012


QUOTE(ngeo88 @ Mar 2 2016, 09:09 AM)
look like you mess up the wiring to ignition and wiring to battery, there should be 3 power wire , one is to chassis should be connect permanent to car metal body to get negative (-);  two Positive (+) 1. To ignition coil so when you turn key off radio is off. 2. To fuse, power direct from battery even your key pull out but your radio clock and memory still preserve because the power from this line are direct from battery.
*
i think wiring for 3 main wire already at its place..i once tried to change red and yellow wire and the result is radio always open nonstop even i dont put key on car..so i presume its already good, maybe grounding fault

QUOTE(6216 @ Mar 2 2016, 08:26 AM)
Aku rasa ground tak betul. Aku punya pun kekadang cam tu. Finally when I got round to it, had to clean up the rust around the grounding. Baru ok.
NTFS tak boleh pakai kat situ. Format to FAT32.
*
QUOTE(rudduan @ Mar 2 2016, 09:20 AM)
try ground the (-) wire dont solder to the faktori koneksyun...and do some grounding la ur car...old car is good good to do grounding...dont buy those cheap fake hks/pivot/greddy/apexi/r3/trd grounding cable...u can diy using better wire la...bestest using 100% pure copper zero oxide cable...but ini my pendapat la...lain orang lain opinion...
*
so how much usually grounding cost ?
i have zero experience on thingy, so this one better lets the pomen do de job
6216
post Mar 2 2016, 10:41 AM

Regular
******
Senior Member
1,003 posts

Joined: Mar 2014
QUOTE(naih @ Mar 2 2016, 10:36 AM)
i think wiring for 3 main wire already at its place..i once tried to change red and yellow wire and the result is radio always open nonstop even i dont put key on car..so i presume its already good, maybe grounding fault
so how much usually grounding cost ?
i have zero experience on thingy, so this one better lets the pomen do de job
*
Its your radio ground not the car's. I think la. It should be solidly grounded to a good point on the chassis. My Iswara punya is under the handbrake console
TSnaih
post Mar 2 2016, 10:44 AM

New Member
*
Newbie
3 posts

Joined: Apr 2012


QUOTE(6216 @ Mar 2 2016, 10:41 AM)
Its your radio ground not the car's. I think la. It should be solidly grounded to a good point on the chassis. My Iswara punya is under the handbrake console
*
ohh i see.. blink.gif how to check, need open dashboard?

4 Pages < 1 2 3 4 >
Bump Topic Topic ClosedOptions New Topic
 

Change to:
| Lo-Fi Version
0.0229sec    0.65    6 queries    GZIP Disabled
Time is now: 15th December 2025 - 10:33 PM