need help ere..
DFI LP CFX3200 + TEAM XTREEM HERMES DDR PC 4800 TCCD

compatible???

at last...

take a look here...

Genie BIOS Settings:

FSB Bus Frequency............................. - 300
LDT/FSB Frequency Ratio....................... - 4.0
CPU/FSB Frequency Ratio....................... - 9.0
RD580 HT PLL Speed............................ - High Speed
HT Bus MMOS Drive Strength.................... - 05
HT Bus PMOS Drive Strength.................... - 05
HT Bus Receiever Impedance.................... - 05
CPU HT Bus Drive Strength..................... - Normal

CPU VID Control............................... - Auto
CPU VID Special Control....................... - dun remember but set till get 1.6v
DRAM Voltage Control.......................... - 2.80v
SB PCIE Voltage............................... - 1.80v
NB Analog Voltage............................. - 1.34v
LDT Bus Voltage............................... - 1.34v
NB Core Voltage............................... - 1.34v


DRAM Configuration Settings:

DRAM Frequency Set............................ - 200=RAM/FSB:01/01
Command Per Clock (CPC)....................... - Enable
CAS Latency Control (Tcl)..................... - 3.0 Bus Clocks
RAS# to CAS# delay (Trcd)..................... - 04 Bus Clocks
Min RAS# active time (Tras)................... - 08 Bus Clocks
Row precharge time (Trp)...................... - 04 Bus Clocks
Row Cycle time (Trc).......................... - 10 Bus Clocks
Row refresh cyc time (Trfc)................... - 16 Bus Clocks
Row to Row delay (Trrd)....................... - 03 Bus Clocks
Write recovery time (Twr)..................... - 03 Bus Clocks
Write to Read delay (Twtr).................... - 02 Bus Clocks
Read to Write delay (Trwt).................... - 03 Bus Clocks
Refresh Period (Tref)......................... - 1560 Cycles
DRAM Bank Interleave.......................... - Enabled
Errata 94 Enhancement......................... - Disable
Errata 123 Enhancement........................ - Auto
Odd Divisor Correct........................... - Disable

DQS Skew Control.............................. - Auto
DQS Skew Value................................ - 0
DRAM Drive Strength........................... - Level 3
DRAM Data Drive Strength...................... - Level 1
DIMM 1/3 Clock Timing Skew.................... - Auto
DIMM 2/4 Clock Timing Skew.................... - Delay 450
Max Async Latency............................. - 8.0 ns
Read Preamble Time............................ - 5.5 ns
IdleCycle Limit............................... - 64 Cycles
Dynamic Counter............................... - Disable
R/W Queue Bypass.............................. - 16 x
Bypass Max.................................... - 4 x
Burst Length.................................. - 4 Bursts

got to 2.7ghz with these settings...

update...
it's very unstable...
right after i quit playing company of heroes for 3 hours then kaput.. (restart laa not blow)

i test running memtest @ 250mhz @ 2.5ghz got no error... 25 pass

can boot into windows but then blue screen....

the vdimm is comfirm @ 2.8v.. reading @ 2.83v

if people using ddr600 with any nf4 mobo i think got no problem... a fren of mine once use this ram got no problem...
try using it on DFI LP CFX3200-DR/G...
u'll will start to cry when u want to set the dram setting...
u have to set each setting properly to get a good result...
i'm alreadi out of idea.....