p/s: I have ask same question in the thermal interface material thread, if anyone already aswer me there, no need to answer here again. Thanks.
Artic silver vs Ceramique, Just a small test..
|
|
 Dec 22 2006, 12:45 PM
Return to original view | Post
#1
|
 
Senior Member
775 posts Joined: Sep 2006 From: Sungai Mati, Muar, Johor ; Now at Wangsa Maju, KL.  
|
If for proc without IHS, that mean bare chip...are rice grain method suitable to uses? or need to apply a thin layer on the chip there?
p/s: I have ask same question in the thermal interface material thread, if anyone already aswer me there, no need to answer here again. Thanks. |
Quote|
|
 Dec 22 2006, 05:09 PM
Return to original view | Post
#2
|
|
Senior Member
775 posts Joined: Sep 2006 From: Sungai Mati, Muar, Johor ; Now at Wangsa Maju, KL.
|
QUOTE(lolhalol @ Dec 22 2006, 04:32 PM) @kataro, if bare naked chip, then i suggest u use a ver very small drop of as5 even smaller than as5 because if the tim touch any of the contact pins, kau kau... mean use even smaller drop than suggested by AS?  last saturday, I put a little drop of AS ceramic on my proc and I can found 1C drop on my proc temp during Idle (OCed to 1.34GHz from 1.2GHz)...just off PC yesterday night since last saturday after reading that need to on and off for the TIM to sink. Maybe I will apply AS5 after Chrismas as I just get my AS5 from moderno on Wednesday... hopefully can drop more C...  |
| Change to: |  0.0140sec
 0.76
 6 queries
 GZIP Disabled
Time is now: 5th December 2025 - 10:11 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.