his 1st time modding but seeing it like it wasn't...

nice cutting, u really change the acrylic window just cause of the ccfl thingy

hahaha, nasib baik, if not onli waste of money lo... why didn't u bought the colored transparent type acrylic from the bulk, if u willing to wait for it + bare any damages done during transit

i know he bought a new jigsaw, but the jigsaw can use multiple times, i was suprised bout the acrylic thingy, he bought a new one onli cause of the uv effect, luckily he can use it on other case mod

eerrr, bout that, i'm sori, wrong info, already checked it, actually they wasn't selling the colored clear type, but they tinted it again sori for the wrong info

This post has been edited by E-J@1: Jan 3 2007, 05:02 PM

why not blow hole it both? can't fit ka? if that the case, better blow hole it on top, cause can exhaust heat accumulate there, ur heat will trap there but not totally trap, eventually it will get out slowly

i wouldn't recommend u to blow hole on the side panel cause u already got 2 fan exhaust the heat from the rear which is the rear fan + the psu fan, i think it will be enough for the 2 fan to exhaust the heat...

That's just my opinion, in the end it's up to u to decide it... just don't blame me if the temp didn't drop, i giving my opinion based on my experience from my "Black Parade" case mod by Ianho cause it''s hard to compare two different cases with the same amount of intake/exhaust fan as it depends on what ur hardware u using (how much heat produce by ur system), the cable management (which can obstruct the air flow) & lots more

can't wait for it

nice setup, really like the sleeving

since u sleeve most of the wires, why didn't u change the molex connector to UVs