Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed

Outline · [ Standard ] · Linear+

> LYN OFFICIAL VAPING THREAD V29, Vaping Is Trending Now!

views
     
JimL
post Nov 11 2015, 11:39 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(nekkidgramma @ Nov 11 2015, 11:19 PM)
Ye turns out I completely forgot to hit 'add reply'.  doh.gif

I wanted to know is the v3.4 can step down in wattage mode or not. Since you have em, assuming in your hand, not stuck in your orifice, have you tried firing it at 7w? Does it hits different than at 20w?
*
Wanna fire at 7W? Go buy an Ego or some 5 year old mod! Lol!
Do you even fire anything at that low? Still steps down when its changed to Joule mode. All TC mods has step down. Dunno why Yihi decided to have it this way. (Joule mode for step down).
Far as I can see the V3.0A was firing hotter in TC. Its adjusted lower in V3.4. My preferred is the V3.0A. Even the V3.0 didn't hit as hard as the V3.0A.
JimL
post Nov 11 2015, 11:44 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(mi-g @ Nov 11 2015, 11:39 PM)
i order some stuff from FT, UD 316L including, on 3 nov.. only today they start packaging the order  mad.gif  mad.gif  vmad.gif  damn ft getting slower
*
Hyper Vape sells UD wires for around RM20. I don't even bother to order UD wires from FT.
JimL
post Nov 11 2015, 11:56 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(mi-g @ Nov 11 2015, 11:49 PM)
but..but...but.... at FT only $2.47 wooo.. that's RM10 plus minus only.. and can collect the rebate point from purchase and review brows.gif

accumulated points now almost 10.. cant wait to change to $10  rclxms.gif
*
Ya...ya....ya.... But you wait till your balls drop!
Chipong! When I bought the UD 316 from FT in Sept it was $3.91!

This post has been edited by JimL: Nov 12 2015, 12:00 AM
JimL
post Nov 12 2015, 08:57 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(rip_code @ Nov 12 2015, 08:51 PM)
Is it compulsory to follow the vape power chart? Recoil and get about 1-1.0XX ohm with about 4V, 15watt. According to the chart, it is in the red zone

Edit. More info is 26awg 6 wraps with 3mm dia
*
Its outdated. Just increase/decrease the watts till you get to a setting you like. Different atomizers/juices will be best at different watts.
JimL
post Nov 12 2015, 09:01 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(nekkidgramma @ Nov 12 2015, 08:56 PM)
As long as you know the limit of your battery and a basic knowledge of Ohm Law, you'll be fine. Just stick to regulated mod until you're confident enogh to handle mech mod, if you're into that.

Sometimes I like to crack up to 15w on a 1.8 ohm build. I like to live dangerously
*
Something you may really like:

https://www.fasttech.com/products/0/1001807...ldable-dripping

https://www.fasttech.com/products/0/1001807...ldable-dripping
JimL
post Nov 12 2015, 11:39 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(nekkidgramma @ Nov 12 2015, 11:22 PM)
Gasp. Magma, is that you?! And have you been doing steroid? Dammit, I loved my Magma and I might love this too.

This is too cruel man sad.gif
*
Really like it?
Eden Mods was supposed to come out with an updated version with additional air holes on the top cap but dunno when that'll be. Then have to wait for clone. Might as well get this first.
http://thevapesnob.com/lifestyle/eden-mods...ap-dragon-v1-5/

YO Vail, tumpang!! Thats two for Nekkid & me and one for yourself!

This post has been edited by JimL: Nov 13 2015, 01:06 AM
JimL
post Nov 13 2015, 03:40 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(Hackezkk @ Nov 13 2015, 12:36 PM)
inside worth $40 only..with coils,drip tip ceramic only..  hmm.gif  hmm.gif
or becoz i have some burner??
https://www.fasttech.com/products/1004/1000...rch-and-lighter
my other package include with burner arrive today without no problem...

which number i should call to ask about it? poslaju?
*
Its normal for it to be presented to Customs. If there's nothing suspicious about your package its handed back to Pos Malaysia for delivery to you. Its happened for every single one of my FT packages but I haven't been taxed or anything.

That Honest Torch is sold here for RM20. You can find it on Lelong.com or pasar malams. I don't even use mine anymore.

Edit: Just checked Lelong. Price went up. It was only RM20 late last year. I bought mine in a pasar malam for rm20.

This post has been edited by JimL: Nov 13 2015, 04:01 PM
JimL
post Nov 14 2015, 04:38 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(Anti-LB @ Nov 14 2015, 03:41 PM)
Thanks for your reply.

I'm interested in buying Kanger Aerotank Mega, this tank I can just buy the replacement coil like http://www.vaporauthority.com/products/gen...al-coils-5-pack and just screw it in, no need to rebuild, buy wire, cotton etc anymore?
*
I would think the Aspire Nautilus or Nautilus Mini would be a better choice than the Aerotank. Airflow on the Aerotank is rather limited. And yes the Nautilus also has replacement coils.
The newer sub-ohm tanks has massive airflow compared to older clearomizers. And some may require a higher powered mod to get the best out of it.
JimL
post Nov 16 2015, 08:35 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(olivur @ Nov 16 2015, 08:26 PM)
it's easier (and safer) to get 26650 batteries and pair it with a chunky mech mod since they have innate higher amp ratings if you plan on building <0.1ohm

those lg batteries while having true 30amp rating, at 0.1 ohm with an 18650 hybrid top cap mech you're already pulling 40+ amp. which is unsafe
*
The HB6 has a max continuous discharge of 40A. Its higher than the 26650 batts.
JimL
post Nov 16 2015, 09:45 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(olivur @ Nov 16 2015, 09:03 PM)
you need at least 5amp headroom than what the batteries are rated to be safe. even tests shows 35amp and 40amp was to be done with caution.

on one point I do stand corrected, which is that the Sony 26650s are basically elusive now and even so they were closer to 30amp than the rated 50amp.

a parallel mech box mod with 25r is still easier to obtain locally to go below 0.1ohm safely.
*
You wanna live forever? Lol!!
Nah, I'm not gonna help anybody become the second De Jay with his vape towel.

The Sony VT 26650 was only good for 26A. But it was best below 20A. You may be able to find some antique stock left on Lelong.com
Development of 26650 batts have fallen behind 18650. The MNKE isn't very impressive as well.
JimL
post Nov 17 2015, 08:36 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(olivur @ Nov 17 2015, 02:03 PM)
for a mech mod, wash with dish soap since it has degreaser > dry > isopropyl rub down threads, inside of tube, switch assembly, floating pin > polish for brass / copper tube, switch assembly or mineral oil rub down for those that's coated. I do an extra step to ensure minimal voltage drop but that's just me

for regulated, just the contacts I guess
*
You missed out the part about the Coca Cola bath! Tomato ketchup as well!
JimL
post Nov 18 2015, 12:16 AM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(kuli2sahaja @ Nov 17 2015, 11:10 PM)
Any washing/cleaning tips for SS tube mod?
*
Lol! I was joking with him about the Coca Cola part. Tomato Ketchup is used to remove stain/patina on copper & brass. SS is really easy to maintain. Just wash with soap and clean the threads. Dry it completely.
JimL
post Nov 18 2015, 03:22 AM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(Hamsom @ Nov 18 2015, 02:44 AM)
Basically no chance of explode or what right? Btw any recommendation for a good basic one? The reason i want to have 1 dripper is for easier change in flavor. If use tank need finish first then change. Very long to wait. Im not a hobbyist. Just trying to reduce or quit smoking and have little fun where i can. So no cloud chasing no problem.
*
Try to get a smaller dripper like a Derringer which is easy to buy locally. A small dripper has a small chamber (reduced chamber) and requires less power than a taller one. A smaller chamber also brings out more flavour. The downside is it does get hot so get a longer drip tip or a drip tip thats not metal.
JimL
post Nov 18 2015, 03:36 AM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(Hackezkk @ Nov 18 2015, 03:29 AM)
if can wait, go for stumpy rda..easier to coil than derringer
*
I would prefer the Stumpy over the Derringer. Bigger drip well, two posts etc. But I've yet to see any local vape shops sell it. The Derringer can be found in many vape shops here.
JimL
post Nov 18 2015, 10:22 PM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(firestonez @ Nov 18 2015, 07:14 PM)
Obs crius rm88 + got 30% and 15% voucher
http://mall.shopee.com.my/shop/#shopid=843625
*
Yo firestonez, how do you like the Crius? I was playing with it last night. I like how idiot proof it is!
JimL
post Nov 19 2015, 02:06 AM

New Member
*
Newbie
2 posts

Joined: Feb 2007
QUOTE(olivur @ Nov 19 2015, 12:41 AM)
lol! and to think I prefer evolv over yihi too. but that chum bait was too potent for me
*

Yo, I saw you had some fun just now. Dammit why'd you stop? My popcorn wasn't ready!

5 Pages « < 3 4 5
Bump Topic Topic ClosedOptions New Topic
 

Change to:
| Lo-Fi Version
0.0576sec    0.57    7 queries    GZIP Disabled
Time is now: 22nd December 2025 - 12:11 AM