get the competition cap by anarchist to support crazy builds c:

which I happen to be selling!

/smooth

what. your mod gets hot? you sure it isn't arcing? when was the last time you cleaned it

Noobie question..... exactly how do you clean a mod?

for a mech mod, wash with dish soap since it has degreaser > dry > isopropyl rub down threads, inside of tube, switch assembly, floating pin > polish for brass / copper tube, switch assembly or mineral oil rub down for those that's coated. I do an extra step to ensure minimal voltage drop but that's just me

for regulated, just the contacts I guess

wad mod u rocking? if u have a super low ohm build any mod will warm up. it's normal. but if it's like super hot than u might wana inspect it
depends on the material ur mod's made off. mine's a full copper.
i run it down with soap water and a brush. for stubborn stains i use tomato sauce. <--- no really. i do. 
then i wipe it down and use cape cod polishing cloth for the blingggggg 
i have a friend who polishes his brass with a polishing wheel. damn shiny 

which version is yours? the original tugboat tube mod had obvious vent holes at the bottom while the v2 tugboat tube which I had in copper had a single vent hole at the switch itself where the flawless logo is. which the cerakoted