I had installed UR Front & Anti-roll bar last 3 months. But, I feel my car front left hand site a bit loose, unstable & bumpy when driving especially cornering recently. So, I thought it could be something wrong with the absorber components. So, sent to SC to check last 3 days, but they couldn't found any problem & mentioned is alignment out & asked to do alignment & balancing that cost me RM68. But, it is no different after the alignment & balancing done. Really feel cheated by them. Need to ask all SIFU able to advise what could be the problem & how can I rectify the problem?
Thanks.
Try to bring back to UR HQ... Sometimes is due to improper installation... Happened to my neighbor using UR bars in his City got shaking when driving above 60km/h... He went to UR HQ and they fixed it for him and they said it was not installed properly by the shop...
This post has been edited by blurjoey: Feb 5 2016, 12:38 AM
anyone use MHL cable to connect HU to your phone? which cable suitable for note 3? already bought yesterday but its not working. that salesman show me cable for samsung s5 and said it will fit also for note 3.
I'm using MHL cable for S3 for my Note 3...
This post has been edited by blurjoey: Feb 23 2016, 11:39 AM
V spec, I have the same issue right now. It happened prior to this but after one night it goes back to being normal. 4 sensors or or 2 sensors at the rear?
It's one of the reverse sensor spoilt, I have replaced the faulty sensor at SC and now back to normal... Under warranty...
Bring it over when having the continuous beep then they check which is faulty...
This not regarding side sensors. It's just one long continuous beep. With nothing blocking at the rear. I'm at the SC now and guess what. It decides to work correctly now.
Happened to me too... Have to go back to SC when it happens again... Then they found out was 1 of the sensor faulty... Then I have to wait about 2 months for stock for the reverse sensor...
i bought the mud guards from hingan yesterday, but when i want to install there is no hole to screw? how to install actually?
You need to screw in... Very easy only... Just use the provided screw to poke a small hole and screw in only...
Can watch this video as it's the same for the front. The rear is a bit different as City no need to remove the inner fender and the clip is at the bottom... The rear bumper have notches which indicates the holes for the mudguard or the bodykit...
This post has been edited by blurjoey: Feb 25 2016, 02:52 PM