guys is those PIAA bulbs plug and play?

wanna install it to try

Yes been fixing quite a number for city headlights hehe

Wait till u try the wiper than u will knw y piaa 😅

Hi..where is this Dent Master?

No wonder not install PIAA wiper anymore. Because of this incident happen to you.

he bank officer ah?

i dunno lar.. serious... he pro car i heard from Taeng lar... and rich izzit?

Three Wong's here. If you want to ask about accessories such as lighting or wiper - can ask Jeremy Wong, Taeng is more on car exterior modification. If need to find real sifu, can look for Noordin Goh. He is an expert in car modification.

shifuu...

Jeremy wong =blurlyjoey= wiper and lighting
taeng= car exterior

real sifu = nording goh? wholly modify car?

your goodselves? > Taeng> blurjoey > nordin goh?

Anyone here using 1 mcgard lock nut and 3 ori nut? 
How does it affect the wheel balancing? 
I weighed them ori n mcgard,  32g vs 60g.

Ic... Did u check their weight diff?  Or feel by hand if there is any significant diff?  I think it would be less than mcgard vs ori.

I feel the diff between them is a little too much n might have vibration issue.  Have yet to test it out.

I'm out of the game. Any assistance can ask those who responded in previous thread. 

This post has been edited by Jeffreynsx: Yesterday, 07:34 PM

There is specific torque for nut... But it's not necessary to follow very closely.  As long as they are tighten reasonably... There is no issue with vibration n other wear n tear issue. 
Nothing to be worried. If your 80lbft is right,  I think my nut is tighten around there.

If u didn't experience any extra vibration before n after using this setup, good for u. 

I have never experience any vibration issue with hand tighten nut on wheels.

My main point is,  introducing only 1 lock nut to each wheel,  and 3 other ori nuts is not recommended as this heavier lock nut induce imbalance rotational force. 

I'm just sharing my knowledge n experience.  Even before installing these lock nuts,  I had this concern, and the result didn't surprise me.

Blurjoey using splinedrive n it's lock nut,  which I think their weight is the same or very very close.  Therefore no vibration issue.  Probably,  can sifu blurjoey help measure the weight when doing tyre rotation then.

On V specs, Does anyones screen dim automatically when on the head lights? I am refering to the touch screen where there is the radio controls.

I had felt that was what happens. But after the recent service, it doesnt do so anymore.

Normal driving - just P
Idle - N
Parking - P
D - Gear 1,2 and 3
S - Gear 1,2

Either use D or S. Depend on condition of environment

Hi all,

I Went and bang my aunty hse side tembok..didnt noe it was that high

Any idea how much to fix it? Is it can ketuk and paint or need to replace whole bumper

Hi Joey...  recommended do outside than Honda is it? Any idea how much will cost?

Proven many drivers never read their car manual.
In fact cvt has no specific gear ratio.

judging from the photos, i think you won't be able to to polish it, looks like already etched into the bumper, best to send to those paint shop, they'll sand it down, fill with bondo and then respray, might cost a couple hundred, which part of the bumper are broken ?
you mean the clips ?

I thought dentmaster doesn't deal with cement n paint...

This case looks like cement is needed.