Guys, i have replaced dual coils wire on a dripper recently and right-after, i put the RDA to be read on ohm reader. The reader was showing 0.03 (previously was 0.50). Due to very low resistance, i didnt fire at all and scared of short circuit and such. The new coils are slightly bigger in diameter and is that the reason for such a low resistance? The new coils are pre-made that came with the dripper.

Hellboy

I just noticed that my nickel build on my ipv4 keep showing the same resistance of 0.15 ohm with whatever build I am on. switched to power mode and checked i can see the correct resistance.

eg: lemo drop - 0.11
      kayfun - 0.06
      subtank- 0.08

but everytime switched to nickel mode it will locked on 0.15 ohm.

I wonder why

Lol. I never knew about this on ipv4. I only know on dna 40 oni. Thanks masta

you have to set resistance on SX chips that has TC.

+ and - together as nekkidgramma said

manual book also got say 

lol. I oso dunno where the manuals went

new vape mail ....
hahhaha can't resist ....
[attachmentid=4691718]