I'm using 185 55 r15. Overall it's much quiet and soft from synergy m5. Handling ok la. Can drive at menora tunnel (where there is giant stripe on the road) at 80kmh without shaking all over the dashboard.

yes. My driver side door even holds water after heavy rain and creates sloshing sound when I corner/move the car.

Did some minor diy since no money buy body kit..
 

lol. that thing fugly la. haha

Just take some car wax and wax your side mirror. Works for me.

Can be adjusted from the lever there inside the cabin. But after sometime, it will still loose like cabut rear wheel hub. Worst is, if being adjust too tight from the inside, the outside brake cylinder will be pull too far, and possibly putus berak kabel

According to magician, many manufacturer that decided to menten use drum berak for the back has already removed such convenient feature as the hole will result in water masuk, hence losing berak when going over flood. Now the thing is, how often does 1 so gangho until going over flood that hai until masuk pintu level?

Another bad thing is, the sensitivity of the drum berak bcum so low simply because too many sohem abused their henberak. Like pull henbrek at 70kph then make the car slide. All this not applicable to our new PL1BTx series GaGa anymore. Even if tighten the berak to 1 click full stop, it will loosen up after few round of tarik.
You should. After the fix, make sure you do maximum 2 clicks to full stop everytime. Prevent from pulling too hard and it shall last longer

I see, previously service I no ask they no do.. Last service they do without ask me lol

Taip R yo

How old is your car unker?

If a few years di, maybe can see if you can refurbish diy spray some exterior black in colour plastic parts. Like what I did. 

Aah yes. How about refurbishing the worn black plastics?

Are they turning white? 

Just like what happened to mine.

Diy rear passenger a/c vent.

The idea is to use the armrest as a blower unit. Some modification required i.e. Inlet louver and blower fan. Can use pc fan also as blower. easier said than done though

I didn't put sponge, just a few strategically placed double-sided tape to hold it in place 

As for DIY ideas.....retrofit projector headlamp 

Pro o 

Hi all..
I had just moved to KL
Anyone can recommend me good mechanic for service?
Prefer around kepong area.
My saga is due for 40k service..
Thanks alot!!