Outline ·
[ Standard ] ·
Linear+
Aircon Discussion V3, Home Appliance
|
MrToper
|
Jun 28 2015, 04:22 PM
|
New Member
|
So I have a 1HP Mr Slim(Looks similar to the Starmex units) unit which I got a few months ago. It's easy to clean and cools quite well. But I was expecting quiet air conditioning but nope. When on high,it sounds like a tornado.
|
|
|
|
|
|
MrToper
|
Jun 28 2015, 04:29 PM
|
New Member
|
QUOTE(supersound @ Jun 28 2015, 04:23 PM) So far only Panasonic fit on cool down fast, quiet operation. Well my old AC unit was a Panasonic. The compressor was making a whole lot of noise and it's not cooling anymore. But the fan noise on the Panasonic was more bearable.
|
|
|
|
|
|
MrToper
|
Jun 28 2015, 05:35 PM
|
New Member
|
QUOTE(kimsim @ Jun 28 2015, 04:57 PM) If you knew how using in proper way, should be not using in high fan speed for common time, except for wanna cold down the room as fast then baru adjust to high fan speed. I'm using it on medium as of now. There's abit of wind noise but if I set to low,I can't feel too much airflow from where im sleeping.
|
|
|
|
|
|
MrToper
|
Jun 28 2015, 08:49 PM
|
New Member
|
QUOTE(kimsim @ Jun 28 2015, 06:14 PM) How long the Aircon has been usage? Try to clean out the filter or gas leaking would be the happening, like normal serving is around 3-4 mths interval regular service will do Well its a fairly new system which is a few months old.There were no gas leaks,just cleaned it. And since I got it there is always that wind noise. On Low you can't hear wind noise but the air flow is really soft.Medium,abit of wind noise but got used to it. High,it sounds like a tornado on drugs(Louder than the Panasonic unit it replaced). The compressor unit is reasonably quiet This post has been edited by MrToper: Jun 28 2015, 08:52 PM
|
|
|
|
|
|
MrToper
|
Jul 11 2015, 09:50 AM
|
New Member
|
QUOTE(nanpengyou @ Jul 10 2015, 05:51 PM) hi guys, i just had installed 5 units ME. the installer said no need to refill the gas for first time installation. can you guys confirm? i feel like not really cold thank you. When my Mr Slim was installed(Brand new btw), the installer didn't fill up the gas since it's already charged in the factory. And it's really cold when I use it.
|
|
|
|
|
|
MrToper
|
Jul 11 2015, 09:59 AM
|
New Member
|
QUOTE(kimsim @ Jul 11 2015, 09:54 AM) There's depend on back to back or either pull from 3m length distance will be poor cooling Well before I got this Mr Slim unit, I got a Panasonic unit and the outdoor unit is mounted on the same wall as where the indoor unit was(Bad idea....Alot of vibrations especially a few months before I got it replaced) When I got the Mr Slim,The outdoor unit was moved a few meters away and it still works fine. Oh and this is how the unit looks like This post has been edited by MrToper: Jul 11 2015, 10:00 AM Attached thumbnail(s)
|
|
|
|
|
|
MrToper
|
Jul 11 2015, 10:29 AM
|
New Member
|
QUOTE(kimsim @ Jul 11 2015, 10:11 AM) Wow left side too close to wall, maybe next time is a bit difficult for wipe out The previous aircons were also installed like that for years since I was in the house.That was in the master bedroom.I got no problems with that install and it's still easy to remove the unit for servicing. Originally I got an Acson in there.Replaced it in 2006 or 2007 with a Panasonic(When it got replaced the Acson was moved to another bedroom in the house since it was still working fine.That Acson unit was then replaced a few months later with a Panasonic unit which has e ion something and Patrol Sensor) The Panasonic in the master bedroom runs good until 2014 when it started to make alot of noise and doesn't want to cool efficiently. When it comes to December, the condenser fins on the outdoor unit is rotting away, making more noise and the indoor unit doesn't want to cool(Even at 16c).The outdoor unit compressor would run for a minute or two then stops running for a really long time. Tried servicing it and still not solving problems. Then just screw it and replaced it with the Mr Slim in January 2015 That's how the Panasonic in the master bedroom looks like before it was replaced with the Mr Slim This post has been edited by MrToper: Jul 11 2015, 10:33 AM Attached thumbnail(s)
|
|
|
|
|
|
MrToper
|
Jul 11 2015, 09:06 PM
|
New Member
|
QUOTE(kimsim @ Jul 11 2015, 04:30 PM) Go with 2.5hp ME starmex inverter you won't regret and the input watt just 1830w @ 22k btu, sure is enough to set on 25c only Oops in MY is call mr slim What's different with Mr Slim and Starmex? Some of the units looks same.
|
|
|
|
|
|
MrToper
|
Jul 11 2015, 11:17 PM
|
New Member
|
QUOTE(leonhart88 @ Jul 11 2015, 10:30 PM) 27 celcius with high fan also i need blanket liao to sleep. why underpowered? underpower means no cold at all liao. 27 celcius even save more than 25 right? this 1/2 hp only 370 watt somemore 22 AND MEDIUM I dont care what people say about me setting that. 25 is good but 22 is nice/
|
|
|
|
|
|
MrToper
|
Jul 12 2015, 01:48 PM
|
New Member
|
This is the Panasonic unit I mentioned in my other posts. Installed it in my other bedroom on 2008 if I'm not wrong. Before this unit there was the Acson unit which came from the master bedroom and that unit was installed for a few months and then the Acson was replaced by this Panasonic. Like the Mr Slim at the master bedroom, the left side is so close to the wall. This unit has Patrol Sensor and e ion thing and all those. Not inverter though It's used everyday with 25c on High speed fan. This unit still works nicely. Cooling is very cold even on 25. Fan noise is loud but got used to it anyway. The only problem I have with it is the swing motor is broken. The swing motor got damaged while servicing it last year for some reason. Everytime the swing tried to move it makes a loud clack clack clack noise and swing is jammed (How to fix that)
This post has been edited by MrToper: Jul 12 2015, 01:55 PM
|
|
|
|
|
|
MrToper
|
Jul 12 2015, 09:46 PM
|
New Member
|
QUOTE(kimsim @ Jul 12 2015, 09:21 PM) My old Panasonic in the master bedroom coil also look somewhat like that. Only more worse.
|
|
|
|
|
|
MrToper
|
Oct 30 2015, 11:48 PM
|
New Member
|
The Panasonic in one of the bedrooms is starting to crap out. Installed in 2008.
The swing motor is failing and making a loud clacking noise when auto swing is on and the fan has a really loud wind speed. Cooling isn't that great on 24
I'm thinking of replacing it. I'm thinking of Hitachi. Are they good?
|
|
|
|
|
|
MrToper
|
Nov 2 2015, 12:27 PM
|
New Member
|
I see on some outdoor units that there is ice forming up at the larger pipe(Circled in the pic) What does this mean? Attached thumbnail(s)
|
|
|
|
|
|
MrToper
|
Nov 24 2015, 09:39 PM
|
New Member
|
I think how I can know how to know that the AC is a China OEM ones. Don't take these seriously.
°Questionable designs °Brand name that you might never heard before °The swinger opens very wide downwards °Outdoor units are same as every other brands. °Indoor units are same or similar as other brands °Remotes are the same as every other brands °Cheap °Some big brands sells the cheaper models. (Like Sharp) °Most of them would have temperature display °Questionable functions.
This post has been edited by MrToper: Nov 24 2015, 11:20 PM
|
|
|
|
|
|
MrToper
|
Nov 26 2015, 08:25 AM
|
New Member
|
QUOTE(kimcil88 @ Nov 25 2015, 10:57 PM) Just from hotel room that using samsung aircon. Not triangle aircon. It is very cold and very quiet. I think the aircon better than mhi. Samsung good ah? My relative's house had 2 Samsung units. They get cold quite quick. And I like the looks of those even for the non triangle ones. One of them is an older unit with the remote response is musical which I enjoyed. The newer in there just beeps. Im having a Panasonic AC which is trying to play with me at the wrong time. I might consider Samsung next. This post has been edited by MrToper: Nov 26 2015, 08:27 AM
|
|
|
|
|