Outline ·
[ Standard ] ·
Linear+
Aircon Discussion V3, Home Appliance
|
keyser soze
|
 Oct 13 2021, 12:31 AM
|
|
QUOTE(lonelymac @ Oct 13 2021, 12:18 AM) i see.. hmm.. normally daikin inverter which model recommends? FTKF? FTKU? which model should I avoid.. cause i see daikin some user complaining on PCB failure.. PCB failure can happen to any brand, so far I know they already improve their PCB to withstand higher voltage. If you don't mind the cost then FTKU is better but also more expensive. FTKF outdoor unit is very small, means the spacing between cooling fins is very close. Will be easier to catching dirt. Might need to chemical clean the outdoor more often. |
|
|
|
|
|
keyser soze
|
Oct 13 2021, 12:58 PM
|
|
|
QUOTE(lonelymac @ Oct 13 2021, 05:31 AM) oh I see.. wah.. i really din notice the ODU. How about the peak power consumption? i noticed FTKU 1.0 and 1.5 peak Watt is almost the same.. does it means that the peak watt is the power consumption when i turn on the aircon and run for first few hrs? I see.. how about non inverter model? is it better to get FTV-A series? I just noticed the 2.5HP FTVP is using microchannel.. whereas others are using fin tube.. any different between these 2? Yes the peak watt usually is the first hour consumption, you also need to relate to the peak cooling load (Btu/h). The ratio of power/Btuh is more important. |
|
|
|
|
|
keyser soze
|
Feb 13 2022, 01:53 AM
|
|
|
QUOTE(kevyeoh @ Feb 12 2022, 11:37 PM) hi, i also have a question here...my aircond usualy generate the jelly and will cause blockage... it is a very old air cond and i find the jelly occurance more frequent lately... will it help if i change to a new aircond? can buy something like this https://shopee.com.my/CP-TABLET---Condensat...HkaAsxGEALw_wcBhttps://www.daikin.com.sg/DSP-Materials/IAQ...ntsforDrainPansput inside drain pan will prevent slime built up. |
|
|
|
|
|
keyser soze
|
Jun 25 2025, 06:07 PM
|
|
|
QUOTE(lifelyms @ Jun 25 2025, 05:55 PM) Hi all sifus, recently I want to install a Panasonic 4 way 3HP inverter cassette at my living room. My question is, is it true that the power source need to be at the outdoor unit instead of indoor unit? As the installer ask me to pull another 3 cable to outdoor (Total become 7 cables). Yes, inverter is power to outdoor then back to indoor. |
|
|
|
|
|
keyser soze
|
Jun 25 2025, 08:15 PM
|
|
|
QUOTE(lifelyms @ Jun 25 2025, 07:14 PM) Thank you very much for the prompt response, some technician say only need 4 cables can install, or it is better to go for 7 cables? Thank you. if you pull power from DB to outdoor unit then you only need 4 cables from outdoor to indoor. If the power supply pulled to indoor then you need 7 cables. |
|
|
|
|
Quote
0.2987sec
0.41
7 queries
GZIP Disabled